-
closeloop1
闭环充电机仿真图,看了这图你就会做充电机了。(Closed-loop simulation charts charger, read this plan you will do a charger.)
- 2011-01-10 16:05:36下载
- 积分:1
-
getd
共轭梯度法,是数值分析中很重要的一种,源码为其在matlab中的实现。(Conjugate gradient method, numerical analysis is a very important one in the matlab source code for its realization.)
- 2009-02-12 00:03:35下载
- 积分:1
-
tfr
matlab 时频分析上面程序第八章的故障诊断的小程序(time-frequency analysis matlab above procedures of Chapter VIII of the small fault diagnosis procedure)
- 2009-02-27 17:54:50下载
- 积分:1
-
simulink_am_pm_fm_ask_psk_model
用matlab7·0软件对通信信号进行调制simulink仿真,它包括am,pm,fm,ask,psk.rar(Matlab7 0 software used for communications signal modulation simulink simulation, which include am, pm, fm, ask, psk.rar)
- 2009-03-12 00:39:54下载
- 积分:1
-
Compressive_Sensing_The_Big_Picture
Compressive Sensing The Big Picture
可以连接到Rice大学等很多网页(Compressive Sensing The Big Picture)
- 2009-12-12 09:41:11下载
- 积分:1
-
xiaoARmodel1
用matlab 语言实现功率谱估计算法,程序中有详细的说明(using Matlab language power spectrum estimation algorithm, the process is described in detail in)
- 2006-06-26 17:00:59下载
- 积分:1
-
octplayer0_20.tar
Player/stage program about slam
- 2015-03-04 19:54:41下载
- 积分:1
-
dpdsimulation_matlab
基带数字预失真DPD算法,实现对功放的非线性矫正,以及功放的模型实现。(Baseband digital predistortion DPD algorithm to achieve nonlinear amplifier correction, as well as the amplifier model implementation.)
- 2014-07-09 10:35:10下载
- 积分:1
-
SFS
实现孤岛检测,在单逆变器或者多逆变器并网运行时,由于故障情况导致的逆变器与主网分离,而产生的不正常现象,可以采用孤岛检测方法实现孤岛检测。(For detecting an island, in a single inverter, or inverter parallel operation, caused by the fault condition of inverter and provids separation, produce abnormal phenomenon, an island detection method can be used for detecting an island)
- 2017-10-09 10:47:33下载
- 积分:1
-
trns
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:45:44下载
- 积分:1