mtd_fangzhenchengxu

检测出波形的峰值，并且输出其在图像上的相关坐标(The peak detected waveform and the output of its associated coordinates on the image)

这个.M文件时利用B样条小波进行的小波边缘提取算法。(This. M file using B-spline wavelet for the wavelet edge detection algorithm.)

系统传输函数测试，使用扫频法测试已知系统的频响特性并绘制相关的频响图(System transfer function test, frequency sweep method is used to test the frequency response characteristics of the known system, and to draw the relevant frequency response diagram)

Visual C＋＋与MATLAB的数字基带传输系统仿真的实现(Visual C++ and MATLAB simulation of digital baseband transmission system to achieve)

说明：  5、绘制散点图。 对发射和接收信号利用scatterplot函数可显示信号星座图的样子及噪声对信号造成的失真程度。在该图中，横轴代表了信号的同相分量而纵轴代表了正交分量。下面的代码还利用了 对接收信号利用modem.deqammod对象的demodulate方法进行解调。解调结果为包含0到15之间整数的列向量。 (5, draw a scatter plot. The transmitted and received signals can be displayed using a function of the degree of distortion scatterplot like and noise signals caused by the signal constellation of FIG. In this figure, the horizontal axis represents the in-phase component signal and the vertical axis represents the quadrature component. The following code is also used to demodulate the received signal using the method of demodulating modem.deqammod object. Demodulation result is an integer from 0 to 15 comprising a column vector.)

详解MATLABSimulink通信系统建模与仿真.源程序(Detailed MATLABSimulink communications system modeling and simulation. Source)

Iterative Closest Point

在matlab中读取.dat文件后，利用函数polyfit和polyval进行拟合作图(In matlab to read. Dat file, use the function polyfit and polyval cooperation plan for the proposed)

WiMAX系统仿真，感觉做得很标准，欢迎参考。(WiMAX System Simulation, feeling very standard to do are welcome to reference.)

说明：  《Matlab控制系统计算机辅助设计》随书程序(&quot Matlab control system for computer-aided design,&quot with the book program)