matlab45

CIC每级位宽计算，包括内插滤波器每一级位宽计算，抽取滤波器每一级位宽计算。(CIC Hogenaner bits calculation)

说明：  1、以不同的视角观察球面 和圆柱面 所围区域。2、画出s(t)=cos(2/3πf0t)的曲线及其付氏变换的曲线.设:f0=1KHz,时域分辨率 dt=0.01ms, 采样点数 N=2k, k>10.（均为M文件）(One to observe the different angles of spherical and cylindrical surface region by Wai. 2, draw s (t) = cos (2/3πf0t) curve and its Fourier transform curve. Established: f0 = 1KHz, time-domain resolution of dt = 0.01ms, sampling points N = 2k, k)

说明：  流体计算传热计算代码，matlab编写的流体力学计算和传热计算程序。-matlab prepared CFD and heat transfer (The Flow of Heat Transfer Calculation Code)

在网上找到的代码 在网上那个找到的系统辨识与自适应控制程序 大家分享(Online to find the code online that found in the system identification and adaptive control procedures to share)

Kernel Orthogonal PLS Supp3

说明：  区间蒙特卡洛潮流算法，当输入变量为确切区间变化时，采用牛拉法计算在该输入变量下的电网区间状态值(The interval Monte Carlo power flow algorithm is used to calculate the state value of the power grid interval under the input variable when the input variable is the exact interval change.)

数值分析——利用牛顿前向插值方法计算atanx的Newton形式的系数(Numerical analysis- interpolation using Newton' s method to calculate atanx before the Newton form factor)

Spread spectrum techniques can be very useful to overcome the communication problems like security and efficient usage of power. In this technique, the information signal to be transmitted is multiplied by the PN code (This is the general case and it can be any kind of sequence.),called spreading code signal. The signal which is obtained after the multiplication of PN code is called spread signal which is then transmitted.

面元法计算机翼气动参数，有nasa上百个翼型库文件，可以手动加载，进行翼型设计时可以选择和profile配合使用(pablo)

AR模形拟合工具，提供AR模型的拟合与模拟(AR model )