ode_0

基于无传感器的矢量控制的matlab的程序框图，经试验，可以正常运转(Based sensorless vector control matlab block diagram, the test can be normal operation)

分频器，利用D触发器做的2、3、5分频器(Divider, made use of D flip-flop divider 2,3,5)

BPSK modulation in Rayleigh channel

inversor controller matlab file

ce tp consiste a définir l plus cour chemin d un graphe avec l algorithme de dijkstra

使用多种算法（DAC、Hyperbolic、DAC、SI、SX、Taylar）实现多传感器对单点定位（采用高斯噪声），其中Hyperbolic与SI为3d定位，其他的为平面定位(Using a variety of algorithms (DAC, Hyperbolic, DAC, SI, SX, Taylar) to achieve single point positioning (using Gauss noise), Hyperbolic and SI are 3D location, and the other is plane location)

提出了一个采用(2,1,7)卷积码+QPSK的中频调制解调方案,并在Xilinx公司的100万 门FPGA芯片上实现了该系统。该系统在信噪比SNR为6dB左右时可实现速率超过1Mbit/s、误码率 小于10-5的数据传输。 (Proposed a use of (2,1,7) convolutional code+ QPSK modulation and demodulation of the IF program, and in Xilinx' s FPGA chip one million on implementation of the system. The system SNR to 6dB signal to noise ratio at about the rate may achieve more than 1Mbit/s, less than 10-5 bit error rate of data transmission.)

说明：  Построение ROI изображения

Random Waypoint Model

用响应面法计算可靠度.已知极限状态方程，变量相互独立，服从标准正态分布。(Calculation of reliability by response surface methodology. Known limit state equation, variables are independent standard normal distribution.)