登录
首页 » matlab » Slide_Control

Slide_Control

于 2010-04-23 发布 文件大小:183KB
0 224
下载积分: 1 下载次数: 0

代码说明:

说明:  上传的是刘金琨著的《滑模变结构控制MATLAB仿真》中所有例子的源程序,非常适合滑模控制的学习。(This is the source of all examples in the book:MATLAB Simulation of Simulation od Sliding mode Controll,which was written by Liu Jinkun .)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • blind
    blind syncronisation
    2009-03-12 12:54:04下载
    积分:1
  • CCAImages
    说明:  matlab写的运动检测 自动实现 十分有用的代码 值得学习!(Motion detection matlab automatically write the code should be very useful to learn!)
    2011-03-25 13:43:34下载
    积分:1
  • tiles
    tiles images........................................
    2011-05-13 04:08:33下载
    积分:1
  • Multipath-fading
    信号在多径衰落信道中传输特性的研究 当信号在无线信道传播时,多径发射和衰减的变化将使信号经历随机波动。因此,无线信道的特性是不确定的,随机变化的。(Signal in multipath fading channel transmission characteristics)
    2013-04-08 16:59:53下载
    积分:1
  • TSFNN
    此源码是关于TS模糊神经网络的matlab源代码,已经运行过。(This source is on TS fuzzy neural network matlab source code, has been run over.)
    2020-09-20 08:07:52下载
    积分:1
  • spectrem
    清华张旭东老师《离散随机信号处理》教材第5章。本章首先简要复习经典谱估计的基本结论,然后分别讨论基于线性系统模型和复正弦模型的功率谱估计方法。(Qinghua Zhang Xudong teacher " discrete stochastic signal processing" textbook Chapter 5. This chapter begins with a brief review of the classical spectral estimation basic conclusion, and then discuss the power spectrum estimation based on linear system models and complex sinusoidal model approach.)
    2013-12-04 20:55:46下载
    积分:1
  • jienan
    基于K均值的PSO聚类算法,使用matlab实现智能预测控制算法,数据模型归一化,模态振动。( K-means clustering algorithm based on the PSO, Use matlab intelligent predictive control algorithm, Normalized data model, modal vibration.)
    2020-11-10 09:59:46下载
    积分:1
  • work
    用matlab语言编的基于粗糙集理论的属性约简程序(matlab roughset)
    2009-05-11 17:07:38下载
    积分:1
  • TT
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:46:57下载
    积分:1
  • MIMO-simulation
    maltab语言编写的MIMO仿真程序。程序中采用双天线发射,单天线接收,通过瑞利信道,计算误码率并绘图。(maltab language MIMO simulation program. Procedures used in the dual-antenna, single-antenna receiver, through the Rayleigh channel, bit error rate calculation and drawing.)
    2011-11-07 19:30:03下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载