lyapunov_wolf

说明：  自适应控制的例程 文件samp.m使用matlab6.5通过(adaptive control routines samp.m documents through the use of matlab6.5)

基于MATLAB的音乐信号处理与分析实验程序(MATLAB-based signal processing and analysis of experimental music program)

说明：  L1 Normalization for quadratic regularization

采用滑模控制和RBF网络来控制对象，采用等效滑模控制的方法，即根据系统的确定部分计算出等效控制量，同时利用一个RBF网络对系统的不确定部分进行补偿得到切换控制量。(Using sliding mode control and the RBF network to control the object, using the equivalent sliding mode control method, namely the determination of the system to calculate the equivalent control part of the volume, at the same time using a RBF network of uncertainty on the system parts to be switched to control the amount of compensation .)

Anisotropic Diffusion

simulate photonic crystal fiber cross section based on matlabe

设计地震子波和反射系数序列，合成单道地震记录，再利用对数分解法求取子波，反褶积得反射系数序列(Design seismic wavelet and reflection coefficient sequence, the synthesis of single-channel seismic recording, re-use logarithmic decomposition strike wavelet deconvolution reflection coefficient sequence)

matlab小车基础仿真，一个matlab的实例，对新手有帮助(matlab based simulation of cart)

本程序实现利用自适应滤波器进行系统辨识,效果良好。(This program implements an adaptive filter system identification, to good effect.)

该文件是在Labview环境下编写的数字滤波器，该滤波器可以针对不同的波形滤去不必要的高频或者低频，留下研究者想要的部分。(The document is written in Labview environment digital filter that can filter out unwanted high frequency or low frequency for different waveforms, the researchers wanted to leave part.)