SMI2

MATLAB语法与绘图,压缩文件里是图片格式文件.(MATLAB grammar and graphics, compressed file is a picture format.)

字符识别 字母识别 基于matlab的字符识别程序(Character Recognition Example (I&II) Pre-processing of Image)

简单的自己写的matlab例程，适合初学者使用下载快速掌握图像处理。(Matlab write their own simple routines for beginners download quickly master image processing.)

Signal_数字信号处理教程MATLAB释义与实现 附带程序(Signal_ definition digital signal processing and implementation with MATLAB tutorial program)

关于矩阵束算法的MATLAB程序，其中还有有关DOA的有关矩阵束算法(MATLAB program for matrix pencil algorithm)

this file implement stochastic method in pattern recognition

1、设计一个62阶低通滤波器，采样频率为9kHz，通带截止频率为3kHz，要求阻带最小衰减50dB。 2、将滤波器系数输出到txt文本文档。 (1, the design of a 62-order low-pass filter, the sampling frequency is 9kHz, passband cutoff frequency of 3kHz, requires a minimum stopband attenuation 50dB. 2, the output of the filter coefficients to txt documents.)

【matlab编程代做】史密斯圆图演示 在编程的时候可以作为参考使用学习下([Do] matlab programming on behalf of the Smith chart demonstrates the programming when you can use as a reference under study)

利用ccs环境、MATLAB环境、DSP（TMS320F2812)、被测对象和Agilient网络分析仪E5071B，构建一个自动测量系统。 相信大部分人都知道基于NI公司的GPIB总线，可以实现自动测量，但NI公司的方案实在太昂贵，采用MATLAB能够大大降低成本。matlab与ccs之间基于RTDX协议进行数据交换，同时matlab基于TCP/IP协议与E5071B之间通信，源码说明如下： （1）RTDX_ok目录：matlab7.0代码，包含了一个用GUI实现的界面和相关的具体代码，特别是在其中实现了SCPI语言来对仪器进行控制。 （2）TMS320F2812目录：包含ccs下的c代码，如果没有做过RTDX的应用，相信这个对你很有启发。(Use ccs environment, MATLAB environment, DSP (TMS320F2812), the measured object and Agilient network analyzer E5071B, construct an automatic measurement system. I believe that most people are aware NI' s GPIB-based bus, you can realize automatic measurement, but NI' s program is too expensive, the use of MATLAB can greatly reduce costs. ccs between matlab and RTDX protocol-based data exchange, while matlab based on TCP/IP protocol and communication between the E5071B, the source described as follows: (1) RTDX_ok directory: matlab7.0 code, contains a GUI implementation with the interface and specific code, especially in one of implementation of the SCPI language to control the apparatus. (2) TMS320F2812 directory: contains ccs of c code, if not done RTDX application, then I think it was very instructive for you.)

Volume of a ball using monte carlo