example_L1General

通过使用matlab程序用内惩罚函数法的对算例进行分析(Matlab procedures through the use of penalty function method used in the analysis of numerical example)

matlab数学源程序代码，自编，用于数学方程组的最小二乘解法(matlab erchengfa equation)

The generating systems use Doubly-Fed Induction Generators (DFIGs) to achieve high conversion efficiency and to reduce the installation cost. This paper presents a modeling and Maximum Power Point Tracking (MPPT) control method of DFIG-based variable-speed wind energy conversion system. The generator considered is a wound rotor induction machine whose stator is connected directly to the grid and the rotor is fed through back-to-back Pulse-Width Modulation (PWM) converters. Stator flux-oriented vector control is applied to control the active and reactive current loops independently. The MPPT control method in a Wind Energy Conversion System (WECS) is proposed. The proposed control solution aims at driving the position of the operating point near to optimality. This is a very important aspect to maintain DFIGs efficiently in a variable wind speed. The wind generator is modeled in RSCAD program which is interfaced with the Real Time Digital Simulator (RTDS).

MATLAB编程（第二版) Stephen J. Chapman 著 邢树军 郑碧波译(MATLAB Programming (Second Edition) Stephen J. Chapman translated by Xingshu Jun Zheng Bibo)

FastSLAM1.0/2.0的仿真，在matlab环境下实现。对研究移动机器人同时定位与建图的研究者是非常不错的参考。(FastSLAM1.0/2.0 the simulation environment in Matlab under. Mobile robots to research the same time positioning and building plans of researchers is a very good reference.)

基于simulink的RS编码译码，分析其误码率，并画出它的性能曲线。(RS code decoding based on simulink, analyze the bit error rate, and draw its performance curve.)

ultrasound imaging. this document has the details of ultrasound imaging system with matlab directions of simulation

ISAR成像 包络对齐采用相关法对齐，相位聚焦采用多普勒中心跟踪法 和秩估计法(ISAR imaging envelope alignment using correlation method align phase focusing using the Doppler centroid tracking method and rank estimation method)

bp网络模式识别仿真实例，包括网络训练程序和网络测试程序(bp )

自己写的程序，处理人体三维数据手部数据时，进行指节切割(Write their own procedures when dealing with three-dimensional data of human hand data, knuckles cut)