Floyd

有两组生物医学的实验数据，一组表示物质成分（TCE），一组表示 温度（temp），数据是在35天中每隔5天采样取得的，将物质成分和温度与时间的 关系画在一张图中。(There are two sets of biomedical experimental data, a group of said material composition (TCE), a group that temperature (temp), data is 35 days in samples obtained every 5 days, the material composition and temperature and time of relations draw on a diagram.)

使用MATLAB程序求一阶倒立摆系统的状态空间以及其极点配置的小程序，对于设计计算一阶倒立摆系统的控制算法及其仿真有较好的辅助作用。(Using the MATLAB program seeking an inverted pendulum system, the state space and its pole configuration applet for the design and calculation of an inverted pendulum control algorithm and its simulation system has good supporting role.)

本文给出Q 矩阵的定义, 在此基础上提出由Q 矩阵构造的LDPC 码新码族(In this paper, the definition of Q matrix Q matrix proposed by the new code of LDPC codes constructed on the basis of race)

压缩感知方法演示，1-D信号压缩传感的实现(正交匹配追踪法Orthogonal Matching Pursuit) 测量数M>=K*log(N/K),K是稀疏度,N信号长度,可以近乎完全重构(1-D signal is compressed sensing to achieve (orthogonal matching pursuit method Orthogonal Matching Pursuit) number of measurements M> = K* log (N/K), K is the sparsity, N signal length, can be almost completely reconstructed)

vc和matlab混合编程，在vc中调用matlab的函数进行计算和处理，本程序中调用了matlab图像处理函数打开图像并进行灰度处理(vc and matlab mixed programming, matlab function calls are calculated and processed in the vc, the program calls the matlab image processing function to open and grayscale image processing)

描述了matlab/simulink环境下三电平变流器的触发装置(Described matlab/simulink environment three level converter s triggering device)

实现模糊PID控制仿真，非常有用，编程人员只需简单修改参数即可。(Fuzzy PID control simulation, very useful, programmers can simply modify the parameters.)

基于LASSO算法的编程 利用了r语言.对线性模型进行了系数估计和变量选择(Programming based on LASSO algorithm, using the R language)

GNSS与惯性及多传感器组合导航系统原理相关代码编程——matlab(GNSS and inertial and multi-sensor integrated navigation system principle code programming - matlab)

利用PO修正MM-UTD计算机载波导缝隙天线阵的方向图(Use PO correction MM-UTD computer containing waveguide slot array antenna pattern)