-
xianxingguihua
线性规划 用于最优化算法中的线性规划最优问题(Linear programming optimization algorithm for linear programming optimization problem)
- 2020-11-17 15:09:40下载
- 积分:1
-
Wiener_standalone.tar
wiener filter for enhancement audio file
- 2010-07-04 14:31:11下载
- 积分:1
-
2D_Mesh_Generator
Generates 2d triangular mesh
- 2012-06-07 19:15:48下载
- 积分:1
-
histcn
compute n-dimensional histogram
- 2012-06-29 23:11:21下载
- 积分:1
-
roboFIS
matlab code for robot command using fuzzy analysis
- 2013-10-09 21:50:25下载
- 积分:1
-
final-review
Multiple input multiple output orthogonal frequency division multiplexing (MIMO-OFDM) is very sensitive to the carrier frequency offset (CFO), which not only affects the channel estimation but also the selection of a minimum error probability based precoder for peak-to-average power ratio (PAPR) reduction such that the system performance will degrade. This paper presents the joint scheme of CFO) and channel estimation in the MIMO-OFDM systems with the minimum error probability based precoder for reducing PAPR. We provide the solution to eliminate the effects of ICI due to CFO mismatch for OFDM with space frequency block codes and spatial multiplexing, drive a generalized linear model and propose a non-iterative reduced complexity model.
- 2014-12-11 23:50:21下载
- 积分:1
-
KeeLoq---Wikipedia
Wikipedia article on KeeLoq
- 2011-01-26 17:53:06下载
- 积分:1
-
drawingMeshify
for fem matlab for solving all 2D and 3D problem
- 2013-04-05 18:44:10下载
- 积分:1
-
Switchsource
基于平均电流法设计的APFC高频开关电源MATLAB仿真模型(APFC MATLAB simulation model of high-frequency switching power supply design based on the average current law)
- 2014-12-11 19:31:58下载
- 积分:1
-
matlab_fn
Matlab M-Files:There are four ways of doing code in Matlab. One can directly enter code
in a terminal window. This amounts to using Matlabas a kind of calculator,
and it is good for simple, low-level work. The second method is to create a
script M-fi le. Here, one makes a fi le with the same code one would enter in a
terminal window. When the fi le is “run”, the script is carried out. The third
method is the function M-fi le. This method actually creates a function, with
inputs and outputs. The fourth method will not be discussed here. It is a
way to incorporate C code or FORTRAN code into Matlab this method
uses .mex fi les. We will not disucss it here.
- 2013-07-09 16:49:20下载
- 积分:1