PSO_Solving_Multi_Aims

相控阵雷达的重要性就不用多说了。本人仔细编写了相控阵雷达的仿真波束图，和切比雪夫加权矩阵波束图。虽然文件不大，但是编的很辛苦的。(err)

智能天线示例代码，请一定要上载质量高而且本站没有的源码。请一定要上载质量高而且本站没有的源码。(Smart antenna sample code, be sure to upload high quality and this site does not source. Be sure you want to upload high quality and this site does not source code.)

The shuffled complex evolution with principal components analysis–University of California at Irvine (SP-UCI) method is a global optimization algorithm designed for high-dimensional and complex problems. It is based on the Shuffled Complex Evolution (SCE-UA) Method (by Dr. Qingyun Duan et al.), but solves a serious problem in searching over high-dimensional spaces," population degeneration". The population degeneration problem refers to the phenomenon that, when searching over the highdimensional parameter spaces, the population of the searching particles is very likely to collapse into a subspace of the parameter space, therefore losing the capability of exploring the entire parameter space. In addition, the SP-UCI method also combines the strength of shuffled complex, the Nelder-Mead simplex, and mutinormal resampling to achieve efficient and effective high-dimensional optimization.

matlab常用的模糊聚类程序，并附有演示程序(matlab fuzzy clustering procedure used, together with demo program)

说明：  这是matlab编写的三个程序的代码以及最后结果，是综合实验时做的(This is three programs written in matlab code and the final result is to do comprehensive experiments)

code matlab permet simulation de algorithmes par matlab dans les domaine de communications mobiles

segmentation of licence plate character

基于OFDM的无线宽带系统仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.(OFDM-based wireless broadband system simulation It contains mainly two parts, ie link-level simulator and system-level simulator.Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx . Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.System- level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.)

kriging拟合帽状图（其他拟也行的哦）。(kriging fitting cap-like figure (other lines are also to be oh).)

link matlab to visual studio