系统辨识

详细介绍了Simulink工具箱，对于系统仿真很有用(Details the Simulink toolbox it is useful for system simulation)

PLL的设计与频率相应 清华大学的讲义 基于低通滤波器的设计绘制开环增益波特图(PLL DESIGN AND FREQUENCY GENERATION Draw open-loop gain Bode plot based on LPF design)

位置指令为幅值为1.0的阶跃信号，r（k）=1.0。网络结构为1-4-1，高斯函数的参数值取Cj=[-2 -1 1 2]T ，B=[0.5 0.5 0.5 0.5]T 。 网络权值学习参数为η=0.30，α=0.05 。PID控制各参数的初RBF网络控制，被控对象为G（s）= 取采样时间为1ms，采用Z变换进行离散化，离散化后的被控对象为 y(k)=-den(2)*y（k-1）-den(3)*y(k-2)+num(2)*u(k-1)+num(3)*u(k-2) 始值为，kp=20， kd=0.3， ki=0.1。 (Position command for the step signal amplitude of 1.0, r (k) = 1.0. The network structure is 1-4-1, the Gaussian function parameters taken Cj = [-2-1 1 2] T, B = [0.5 0.5 0.5 0.5] T. Weight learning parameter η = 0.30, α = 0.05. PID control parameters at the beginning of each RBF network control, the controlled object is G (s) = take the sampling time is 1ms, using the Z transform discrete, discretized controlled object is y (k) =-den (2)* y (k-1)-den (3)* y (k-2)+num (2)* u (k-1)+num (3)* u (k-2) initial value, kp = 20, kd = 0.3, ki = 0.1.)

Matlab高级讲义- SIMULINK仿真基础(Matlab senior notes- SIMULINK based simulation)

利用AR模型对电力系统间谐波信号进行功率谱分析的matlab程序，另附一篇相关文章。(AR model using inter-harmonics on the power system signal analysis power spectrum matlab procedures related to a separate article.)

simulation and software radio for mobile communication

说明：  基于MATLAB单神经元PID控制源程序(MATLAB-based single neuron PID control source)

双馈风机模型，基于matlab/simulink软件实例，修改参数后得到，能实现顺利运行。(DFIG model, based on matlab/simulink software instances, the modified parameters obtained, to achieve a smooth operation.)

Matlab有关改进的PSO算法程序基于三种惯性参数改进的粒子群算法程序,并使用测试函数Goldstein进行结果比较(Matlab program for improving the PSO algorithm is based on three inertial parameters improved particle swarm optimization program and use the results of the test functions were compared Goldstein)

扩频程序 主要是采用m序列，对发送数据进行扩频(SPREAD PROCESS)