s3c2410iic

CC2530的T1定时器计数实验，T1初始化实验(CC2530' s T1 timer counting experiments)

基于STM32 hal库的CAN驱动，仅有驱动部分，收发均测试通过。(The CAN driver based on STM32 Hal library only has the driver part, and both transceivers and receivers have passed the test.)

说明：  SAR ADC driver circitery design

ALIENTEK MINISTM32 实验18 触摸屏实验(ALIENTEK MINISTM32 )

基于StC89C52单片机的nRF24L01驱动及应用程序， 已经调试成功(Driver and application program of nRF24L01 based on STC89C52 MCU has been debugged successfully.)

硬件资源: 1,DS0(连接在PA8)，DS1(连接在PD2上) 2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面) 3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏) 4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP) 实验现象: 通过按键KEY_UP可以控制定时器AutoReloadTimer_Handle的开启，这个是 周期定时器，一旦开启就会不断的运行，直到按下KEY1将其关闭。按下KEY0 可以打开定时器OneShotTimer_Handle，这是个单次定时器，只会运行一次， 运行周期到了以后就会停止运行，除非按下按键KEY0将其再次开启。(Hardware resources: 1, DS0 (connected to PA8), DS1 (connected to PD2) 2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340) 3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen) 4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP) Experimental phenomena: The timer AutoReloadTimer_Handle can be turned on by keying KEY_UP. This is The periodic timer will run continuously once it is turned on until KEY1 is pressed to turn it off. Press KEY0 You can turn on the timer OneShotTimer_Handle, which is a single timer and only runs once. The run cycle will stop after that unless KEY0 is pressed to turn it on again.)

说明：  MPU6050能够根据手势变化产生不同数据，经过stm32处理后控制小车的运动(Mpu6050 can generate different data according to gesture changes, and control the movement of the car after STM32 processing)

说明：  stm32_I2C1602完整驱动程序, 程序能运行，有兴趣的可以看看。(stm32_ I2c1602 complete driver, the program can run, interested can see.)

leds blinking for lpc2148

西门子ppi通讯，新人上传的第一个代码，请多关注，谢谢大家了(Siemens PPI newsletter, the first code uploaded by newcomers, please pay more attention. Thank you.)