Continuous_GA

MATLAB的车牌定位程序~能够实现车牌的定位~不过效果有待提高~请高手们指点指点~()

使用MATLAB软件来生成决策树的系列代码(Matlab routine of decision tree)

通过解读RBM算法，利用代码理解RBM算法。(Through the interpretation of RBM algorithm, using code to understand RBM algorithm.)

说明：  编程观察无穷级数 1/n的收敛性。 采用 IEEE 单精度浮点数，观察当 n 为何值时求和结果不再变化，将它与理论分析的结论进 行比较 (注：在 MATLAB 中可用 single 命令将变量转成单精度浮点数)。(Programming observation of convergence of infinite series 1/n)

这是一个 matlab 程序控制的设备，例如打开一扇门。 神经网络的语音命令设计与 PLC 和火车。 进行小的修改，它可以连接到 microcontrooler 模式仿佛 Ardruino

動態聚類k-means演算 將輸入在程式中的數據資料 給予適當的分群(dynamic clustering k-means figure:proper hiving off of input datum in programme)

课程设计中首先采用Ising model的思想建立一个二维的模型，然后利用重要性抽样和Monte Carlo方法及其思想模拟铁磁-顺磁相变过程。计算了顺磁物质的能量平均值Ev、热容Cv、磁化强度M及磁化率X的值，进而研究Ev、Cv、M、X与温度T的变化关系并绘制成Ev-T图、Cv-T图、M-T图、X-T图，得出顺磁物质的内能随着温度的升高先增大而后趋于稳定值；热容Cv、磁化率X随着温度的升高先增大后减小；磁化强度M在转变温度Tc处迅速减小为零，找出铁磁相变的转变温度Tc大约为2.35(First of all, curriculum design idea of the Ising model used to establish a two-dimensional model, the importance of sampling and then use Monte Carlo simulation methods and their idea of ferromagnetic- paramagnetic phase transition process. Paramagnetic material calculated average energy Ev, heat capacity Cv, magnetization M and susceptibility X value, and then study Ev, Cv, M, X and temperature changes in the relationship between T and plotted into Ev-T map, Cv- T diagram, MT map, XT maps drawn paramagnetic material can be increased as the temperature increased and then stabilized value heat capacity Cv, magnetic susceptibility X as the temperature increases after the first minus small magnetization M in the transition temperature Tc decreases rapidly to zero Department to identify ferromagnetic phase transition around the transition temperature Tc for 2.35)

使用matlab编写的crc循环码编译码仿真程序(Crc prepared using matlab simulation program coding and decoding of cyclic codes)

有PMUSIC 校正前和校正后的比较，Relief计算分类权重，抑制载波型差分相位调制。( A relatively before correction and after correction PMUSIC, Relief computing classification weight, Suppressed carrier type differential phase modulation.)

k-均值算法，主要进行在matlab中的程序实现，进行图像的分割处理(k-means algorithm, mainly for the program in the matlab implementation for image segmentation)