cpf

实现了两电平逆变器上异步电机直接转矩控制仿真,引入了一种典型的直接转矩控制改进算法DSVM,并进行了仿真(DTC)

Inverse kinematics algorithm for Robot position control. Based on end chapter problems in Sciciliano et al book for Robot motion control. Different methods are used and their results provided.

说明：  本程序基于matlab，采用牛顿拉夫逊法，对33节点潮流进行计算。(Calculating Power Flow of 33-Node Power Grid by Newton-Raphson Method)

小电流系统接地选线仿真模型及稳态零序功率方向法仿真算法(Simulation model of grounding fault location for small current system and simulation algorithm of steady zero sequence power direction method)

光伏控制器，自动充放电控制12V/10A光伏控制器（ERA-04-10-A）： 额定工作电压：DC12V 最大充电电流：10A 最大放电电流：5A/路（共两路负载） 太阳能组件开路电压：25V 空载电流：<15mA 温度补偿：-20Mv/°C 工作环境温度：-25°C～+50°C 使用海拔：<5500M 控制器尺寸（mm）: 光控电压（25°C）：<=3.3V 过放保护电压（25°C）：<10.8V 过放恢复电压（25°C）：>10.8V 过充保护电压（25°C）：>15.0V 过压保护电压：17.68V 过压恢复电压：14.7V 浮充电压（25°C）：13.4V～13.7V 恢复正常充电电压（25°C）：13.2V 结束正常充电电压（25°C）：15.0V (PV controller, automatic charge and discharge control 12V/10A PV controller (ERA-04-10-A): Rated voltage: DC12V Maximum charge current: 10A Maximum discharge current: 5A/Road (a total of two loads) Solar components of the open circuit voltage: 25V No-load current: < 15mA Temperature Compensation:-20Mv/° C Operating Temperature:-25 ° C ~+50 ° C with elevation: < 5500M Controller Size (mm): light control voltage (25 ° C): < = 3.3V over-discharge protection voltage (25 ° C): < 10.8V over-discharge recovery voltage (25 ° C):> 10.8V overcharge protection voltage (25 ° C):> 15.0V over-voltage protection Voltage: 17.68V overvoltage recovery voltage: 14.7V float voltage (25 ° C): 13.4V ~ 13.7V back to normal charging voltage (25 ° C): 13.2V end of the normal charging voltage (25 ° C): 15.0V)

用ASP写的网上教学交互平台,有利于网上教学,适网上求学()

协同通信中AF模式情况下功率分配优化算法，优化源节点和中继节点的功率分配。(Collaborative Communication AF mode power allocation optimization cases, optimizing the source node and relay node power distribution.)

说明：  微磁学模拟6层纳米线磁矩翻转过程,用于oommf计算软件(This is a micromagnetic simulation program file used in oommf, which can be use to calculaue the six layer's nano line.)

地震勘探反演方法 正演延拓 假设炮点在地层最底层，向上延拓(Forward seismic inversion method assuming continuation shot in the bottom of the formation, upward continuation)

家电维修源码自用的 家电维修源码自用的(jiadianweixiuyuanma ziyongde)