plotTracking

一个锁相环路，同相正交环路，一阶锁相环，做毕业设计时遇到的。(A phase-locked loop, quadrature-phase loop, the first order PLL, the design experience to do graduate.)

Matlab .m files for load flow of 4 bus system.

simulation of a 10 ph induction machine in simulink matlab by a various results and plot

说明：  该文件夹中，包含的为遗传算法工具箱的程序。(The folder that contains the genetic algorithm toolbox for the procedure.)

Combine GMM and UBM in speaker recognition

说明：  用matlab画电场,MATLAB与FDTD联合仿真，绘制出电场磁场电流分布图(Matlab to draw the electric field)

本书既可作为理工科院校研究生、本科生系统学习的教材，又可以作为广大科技工作者掌握和精通 MATLAB的自学用书和使用手册。 (This book can be used as a post-graduate colleges of science and engineering, a systematic study of teaching undergraduates, but also as a vast number of scientific and technological workers and proficient in MATLAB to master the self-study books and manuals.)

simulates the behavior of an asset value over time

2005年J.S.Smith提出的局域均值分解LMD(Local mean decomposition)的原始文献，该方法可用于故障诊断、特征提取、振动信号分析等多领域，是较EMD更为温和的一种自适应算法，目前是热门研究方法。(This is the original article about LMD——Local mean decompositon. Ihis method is a novel adaptive decomposition. It is more better than EMD and achieve more and more attention.)

针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada)