登录
首页 » matlab » EXIT

EXIT

于 2009-07-12 发布 文件大小:3422KB
0 464
下载积分: 1 下载次数: 513

代码说明:

  本源码包参考英国Southampton大学Robert G. Maunder教授2008年的EXIT charts开源demo,给出了通用(分量码多项式可自定义)并行级联Turbo码的EXIT charts的作图源码。同时可完成迭代轨线、BER等值线的绘制等工作。 由于对于码块长较大的情形仿真需要较长时间,源码包也给出了部分分量码多项式的仿真结果,可直接用于绘图。 源码包还给出了最经典的S.Ten Brink介绍EXIT charts基本原理的参考文献,以及本人对通信系统中迭代译码过程分析技术综述的小论文,希望对大家有所帮助。(This source package comes after Professor Robert G. Maunder s open source demo about EXIT charts in 2008 from University Southampton, UK. It is designed for universal (constituent code generation polynomial can be customized) Parallel Concatenated Turbo Code EXIT charts. The iterative trajectories and BER contour drawing is also completed in this package. Since the long block case costs a lot of simulation time, some simulation results are included in the package. We also give the most classical introduction to the basic principles of EXIT charts from S. Ten Brink, as well as a document about analysis technologies for iterative decoding process in communication systems. Hope this will help.)

文件列表:

EXIT
....\demultiplex.m
....\encoderm.m
....\EXIT_g(111113)_EbN0_-0.2_rate_0.33333.mat
....\EXIT_g(2337)_EbN0_0.8_rate_0.5.mat
....\EXIT_g(2537)_EbN0_-0.2_rate_0.33333.mat
....\EXIT_g(2537)_EbN0_0_rate_0.33333.mat
....\EXIT_g(3721)_EbN0_0.6_rate_0.33333.mat
....\EXIT_g(3721)_EbN0_0.6_rate_0.5.mat
....\EXIT_tc.m
....\EXIT图在迭代过程分析中的应用.pdf
....\g(2337)_EbN0_0.8_rate_0.5.fig
....\g(2537)_EbN0_-0.2_rate_0.33333.fig
....\g(3721)_EbN0_0.6_rate_0.33333.fig
....\g(3721)_EbN0_0.6_rate_0.5.fig
....\generate_llrs.m
....\int_state.m
....\invJ1.m
....\J1.m
....\jac.m
....\logmap.m
....\measure_mutual_information_averaging.m
....\measure_mutual_information_histogram.m
....\readme.txt
....\rsc_encode.m
....\tcencoder.m
....\Traj_g(111113)_EbN0_-0.2_ntraj_1_rate_0.33333_L_10000.mat
....\Traj_g(111113)_EbN0_-0.2_ntraj_5_rate_0.33333_L_50000.mat
....\Traj_g(2337)_EbN0_0.8_ntraj_10_rate_0.5_L_10000.mat
....\Traj_g(2537)_EbN0_-0.2_ntraj_1_rate_0.33333_L_10000.mat
....\Traj_g(2537)_EbN0_0_ntraj_1_rate_0.33333_L_10000.mat
....\Traj_g(3721)_EbN0_0.6_ntraj_10_rate_0.5_L_50000.mat
....\Traj_g(3721)_EbN0_0.6_ntraj_1_rate_0.33333_L_10000.mat
....\Traj_g(3721)_EbN0_0.6_ntraj_1_rate_0.5_L_10000.mat
....\Traj_tc.m
....\trellis.m
....\[1] Iterative decoding of binary block and convolutional codes_1996.pdf
....\[2] Extrinsic information transfer functions_model and erasure channel properties_2004.pdf
....\[3] The EXIT chart-introduction to extrinsic information transfer in iterative processing_2004.pdf
....\[4] Convergence behavior of iteratively decoded parallel concatenated codes_2001.pdf

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 注释齐全
    说明:  MIMO线性预编码的ZF,MMSE算法,程序可以直接运行并且注释齐全,大胆放心下载吧(ZF, MMSE algorithm of MIMO Linear Precoding)
    2021-04-07 15:09:01下载
    积分:1
  • Smart-Antennas-For-Wireless-
    描述了智能天线在无线通信环境下的各种应用。(Describes a smart antenna in a wireless communication environment, a variety of applications.)
    2013-09-09 20:30:32下载
    积分:1
  • 搭建BPSK+编码+交织仿真通信链路
    说明:  搭建 BPSK+编码+交织仿真通信链路,仿真分析在不同信道条件下的不同译 码算法的误比特率性能。基于 matlab,搭建 BPSK+卷积编码+交织通信收发链路, 仿真参数如下: 1) 信源比特速率: 100 b R kbps = 2) 卷积编码:码率为 1/2,生成多项式为(561,753) 3) 译码方式:维特比译码(硬判决译码、软判决译码(8 比特量化)) 4) 交织:行列交织,交织器深度为 100bit,宽度为 10; 5) 仿真点数:106 1. 在 AWGN 信道下,仿真并绘出该系统在硬判决和软判决(3bit 量化)两 种译码方式下的信源误比特率曲线,并进行分析。 2. 设定某种交织器结构,在单径瑞利衰落信道( 100 d f Hz = )下,采用理 想信道估计,仿真并绘出该系统在有无交织、不同译码方式(硬判决和 软判决)时,在不同 0 b EN下的信源误比特率曲线,并进行分析。 3. 改变交织器结构,选择三种不同的交织深度(自行决定),在单径瑞利衰 落信道( 100 d f Hz = )下,仿真并绘出该系统在不同交织长度时,在不 同 0 b EN下的信源误比特率曲线,并进行分析。(Build a BPSK + encoding + interleaving simulation communication link, and analyze the different translations under different channel conditions The bit error rate performance of the code algorithm. Based on MATLAB, BPSK + convolutional coding + interleaved communication transceiver link is built, The simulation parameters are as follows: 1) source bit rate: 100 b r Kbps = 2))
    2020-05-15 12:24:37下载
    积分:1
  • 编码识别(matlab代码)20180111
    说明:  卷积码、RS码、LDPC码、turbo码的生成及识别。(Generation and recognition of convolutional codes, RS codes, LDPC codes and TurBO codes.)
    2021-04-14 18:58:55下载
    积分:1
  • Estimate cfo
    基于OFDM系统,实现classen,Moose提出的频偏估计技术,(Frequency offset estimation technique proposed by Classen and Moose based on OFDM sys)
    2017-11-10 09:42:35下载
    积分:1
  • Protograph_EXIT_chart-master
    说明:  matlab ldpc EXIT code
    2020-02-28 12:43:26下载
    积分:1
  • internal-staffs-learning-materials
    华为内部员工学习资料,对于想进华为的朋友会有很大帮助。(The internal staff s learning materials in huawei is more helpfull for someone who want to go huawei.)
    2012-02-17 11:43:08下载
    积分:1
  • 新建文件夹
    说明:  维纳滤波 自适应滤波 随机生成模拟信号与数字信号,加入高斯白噪声之后进行滤波(Implementation of Wiener filter and adaptive filter)
    2019-11-24 19:25:05下载
    积分:1
  • MIMO
    说明:  mimo 多输入多输出 空时自适应处理 STAP 阵列信号处理 Array signal processing(Array signal processing,space time adaptive processing MIMO-STAP SIMULATION)
    2021-03-27 11:59:11下载
    积分:1
  • all_files
    bluetooth matlab GFSK 调制解调, 误码率统计(bluetooth matlab GFSK modulation & demodulation)
    2018-10-24 11:18:54下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载