matlab

三参数模型 系统辨识 自己编写的通过了测试，并写了论文(The three-parameter model system identification adopted their own written)

horn-schunck算法的MATLAB函数 (horn-schunck algorithm MATLAB function)

电子通信系统的建模与仿真 第9章 天线及智能天线仿真 9.1 全向天线的波束下倾 9.2 天线阵的波达方向估计 9.3 天线阵的波束形成?(Electronic communications system modeling and simulation of Chapter 9 of the antenna and smart antenna simulation 9.1 omnidirectional antenna beam antenna array under the dump 9.2 Direction of Arrival Estimation 9.3 Antenna Array Beamforming ?)

对gpr跨孔进行处理的程序，有助于地质专业的学生进行学习与研究。(the programe is for geometry students in sdutying end anlysis.)

不同信噪比对误码率性能的影响，仅供参考，效果还可以(BER performance of different signal to noise ratio on the impact of reference only, the effect can be)

sampencandApEn.m 为证明 样本熵 较 近似熵 更准确的程序 fast_ApEn1.m sampenc.m 为sampencandApEn.m的子程序(sampencandApEn.m sample entropy to prove more accurate than the approximate entropy procedure 3.fast_ApEn1.m sampenc.m subroutine is sampencandApEn.m)

Use of FFT to compute Continuous-Time Fourier Transform

Matlab交通仿真程序用于仿真交通红绿灯的设计！(Matlab traffic simulation program for the simulation of traffic lights design!)

利用Matlab软件的GUI界面编程，通过此界面调用相关的程序去实现由抽样判决后的AMI码型、CMI码型和HDB3码型数字序列恢复出原始的PCM脉冲编码信号。(GUI interface using Matlab software programming, make a simple interface, this interface by calling the relevant procedures to implement the decision by sampling pattern after AMI, CMI HDB3 code pattern and sequence of digital pulses to recover the original PCM encoded signal.)

说明：  本程序运行需一个小时左右。优化准则是旁瓣电平最小。取栅格间距为lemda/2,阵元间距为栅格间距的整数倍。放阵元的位置放1，否则放0(This program should be running an hour or so. Rule of optimization is side-lobe level minimum. Take grid spacing for lemda/2, spacing for grid spacing array (integer times. Put the position of the array (put 1, otherwise put 0 )