AGC

说明：  本资料是关于dsplib的使用说明，其中还包括了各种算法的源码(This information is for use on the dsplib, including the source of various algorithms)

正交频分复用系统中信号的调制与解调，我们用傅里叶反变换和变换来实现(Orthogonal frequency division multiplexing system signal modulation and demodulation, and we use the inverse Fourier transform to achieve transform)

CCS 教程，对于初学者很重要的，经典的(CCS guidance for beginners very important, the classical)

qpsk完整解调，包括载波同步，位同步采用迟早门，载波同步采用判决反馈(qpsk complete demodulation, including the carrier synchronization, bit synchronization using the door sooner or later, the use of decision feedback carrier synchronization)

编写MATLAB程序，数值求解转子动力学分岔图(The MATLAB program is programmed to solve the bifurcation diagram of rotor dynamics.)

CCS 开发环境下 EMIF接口上的SDRAM 测试程序(SDRAM test program for DM64X on EMIF interface in CCS)

Jakes提出了基于正弦波叠加法的Jakes仿真模型。Jakes仿真模型是一种确定模型，产生的信号非广义平稳且不具各态历经性，其二阶统计特性与Clarke参考模型也相差较大。(Jakes fading channel model)

说明：  qpsk的调制解调，使用simulink实现(QPSK modulation and demodulation, using Simulink to achieve)

dsp2812 sci的例子，希望能有帮助(dsp2812 sci example, hoping to help)

传统的DSP 控制通常针对的是三相系统,其外设资源不能满足多相逆变器的控制要求,文中 提出一种DSP + FPGA 的控制器解决方案. 特别利用了FPGA 逻辑资源丰富,编程灵活的特点,设 计了译码电路、脉冲发生、串口通信、看门狗保护、硬件状态锁存等功能单元,在有效扩展系统功能 的同时,降低了运算单元的负荷,提高了整体性能. 对设计进行了时序仿真,并将其应用于8 MW逆变器的控制系统中,结果验证了设计方案的功能性与可靠性.(Traditional DSP control is usually targeted at three-phase system, its peripherals resources can not meet the requirements of multi-phase inverter control, the paper presents a DSP+ FPGA controller solutions, especially the use of the FPGA logic resource-rich, flexible programming characteristics, the design of the decoding circuit, pulse, serial communication, watchdog protection, hardware, latches and other functional unit state, the effective expansion of system functions, while reducing the computing unit load, improve the overall performance of the design for timing simulation, and applied to 8 MW inverter control system, the results validate the design' s functionality and reliability.)