Garch

本资料为基于MATLAB和SINMULINK的16点QAM的数据传输研究。内含MATLAB源代码和用分立模块搭建的SINMULINK仿真图。(This information is based on MATLAB and SINMULINK of 16:00 QAM data transmission research. Contains MATLAB source code and the use of discrete simulation module built SINMULINK map.)

exercice for matlab code in machine learning

说明：  Chan算法，可以用于求非线性方程组的解(Chan algorithm for solving non-linear equations)

This a plat for for computing NSF index in quality management of water quality.

matlab 智能算法30例介绍，其中有背景，分析，程序，供大家参考。(matlab introduce intelligent algorithms 30 cases, including the background, analysis, procedures, for your reference.)

最大熵复原算法,用来处理图形复原重构，以及重建(Maximum entropy restoration algorithm)

If you cannot open or load the old format mdl files on your latest version of simulink. You just run this file. you can open and load the old legacy format mdl files on you latest version of simulink

image fusion in average method

当M=4时的，在0db、10db、20db时的情况下，在星座上观察接收到得信号，并进行分析(When M = 4 when, in the 0db, 10db, 20db circumstances at the time, observed in the constellation to receive a signal, and an analysis of)

极点配置（Pole Placement）设计是控制系统设计中的一种常用设计方法，它能适应逆不稳系统和开环不稳定系统的情况，并且有设计方法直观、动态性能好、系统稳定的特点。((Pole Placement) pole placement design is a common design approach in the design of the control system can adapt to the inverse unstable system and open-loop unstable system, and intuitive design methods, dynamic performance, system stability characteristics.)