MAPBCJR

实现LDPC编码和译码，利用C语言编写，在matlab环境中画性能曲线。(Realize encoding and decoding of LDPC codes)

psk调制,在matlab命令区输入bpskdigital[1 0 1 1 0 0 1 0],1]按运行,即可看到调制波(Psk modulation, input bpskdigital [1 0 1 0 0 0] in the matlab command area, 1] press operation, you can see the modulation wave)

这是一个CD4067B的技术资料，希望对大家有帮助。(This is a CD4067B technical information, we hope to help.)

仿真源码包括了多层异构蜂窝网络中基于齐次泊松点过程（HPPP）的建模方法，一篇介绍该模型的12年发表在IEEE trans的论文。以及传统六边形建模方法和信道增益矩阵的计算。(Simulation source code, including the multi-heterogeneous cellular networks based on homogeneous Poisson point process (HPPP) modeling method, a description of the model' s 12-year papers published in IEEE trans. And traditional modeling methods and hexagonal channel gain matrix calculation.)

用于生成多用户的单通道的跳频信号的子函数(Frequency Hopping Signal for Generating Multi-user Single Channel)

这是一个matlab和optisystem联合调试用的误码率计算程序，里面的文件报过一个可以用optisystem7和optisystem13可以打开的OSD仿真图，还有一个MATLAB计算BER的程序。给出了如何设置系统的大纲。从OptiSystem的电信号输入到Matlab组件。当OptiSystem运行时，它将调用Matlab组件中的M文件，处理数据，然后将所得的电信号导出回OptiSystem。然后将输出信号连接到BER分析仪。经过我调试，文件齐全，放心下载(The attached image gives an outline of how the system should be setup. You should start with inputting the electrical signal from OptiSystem into a Matlab component. When OptiSystem runs, it will call the M-file in the Matlab component, process the data, and then export the resulting electrical signal back into OptiSystem.The output signal is then connected to the BER Analyzer.)

大规模MIMO信道容量分析，主要分析了BS和MS天线数不断增大时，对信道容量的影响。(The analysis to Massive MIMO channel capacity as the antennas of BS and MS grow up. )

这是DTMB标准的发送对的MATLAB建模，包括多种信道模型和多种调制方式，可以进行灵活切换。(This is the DTMB standard to send the MATLAB modeling, including a variety of channel models and a variety of modulation, can be a flexible switch.)

说明：  DRM 外辐射源雷达的杂波抑制算法代码，LMS RLS ECA 有问题。(The code of clutter suppression algorithm for DRM external emitter radar has some problems with LMS RLS ECA.)

使用verilog实现全数字16QAM调制器，载波频率1MHZ，数据比特流的速率为100Kbps,(the modulation of 16QAM based on FPGA)