mfiles

draws and plot acircle

基于matlab的二阶微分动力学的智能体flocking数值模拟，其中每个智能体的动力学用微分方程来描述，给出每个个体组后的最后位置与运动方向。(a matlab code for second-order differential multi-agent flocking simulation, each agent s dynamics is described by using differential equation. it gives the figure of all agents position and velocities.)

该SIMULINK程序描述的是有源滤波器(APF)挂载在电网后滤除了电网的谐波电流。(This demonstration illustrates the use of a shunt active harmonic filter (AHF) to minimize the harmonic content propagated to the source a non-linear load.)

用MATLAB实现采样率转换的程序，附有说明文档，包括内插和抽取，以及先内插再抽取的程序(Using MATLAB to achieve sample-rate conversion process, with documentation, including interpolation and decimation, and interpolation and then taken before the procedure)

说明：  example for linear optimization

说明：  costas环基于matlab的simulink的仿真实现(costas loop in simulink matlab-based simulation to achieve)

matlab命令汇总，里面的命令很全，基本上都是常用的命令(the matlab command summary, is the whole command inside basically used commands)

非平稳信号经过分解后，对其进行谱分析，此希尔伯特谱程序，弥补了了以前的缺陷(Non stationary signal through decomposition, the spectral analysis, the Hilbert spectrum procedures, make up for the previous defect)

该代码为带动量项的PID神经网络的系统控制算法(The code to drive the amount of items PID neural network system control algorithm)

根据给定的每15min预测一次的负荷数据，利用灰色预测GM（1,1）理论进行预测，并分别预测一周内周末和工作日的负荷变化情况，最终形成负荷变化曲线(According to the given load once every 15min forecast data, the gray prediction GM (1,1) theory to predict, and are predicted load changes within a week on weekends and weekdays, eventually forming the load curve)