lxjw

The files explain aliasing , gibbs, dft and fft. All are very useful in signal processing applications and the files illustrate the contents very well with plots/graphs.

飞机平飞性能计算，确定飞机的平飞性能，包括平飞最大速度、平飞最小速度。(Calculation of level flight performance of aircraft to determine the level flight performance of aircraft, including the maximum level flight speed, minimum speed level flight.)

接收端采用的算法和程序流程与发送端发送的OFDM符号的帧结构有关系。具体的帧结构，以及定时估计，频偏估计，剩余误差跟踪的算法可参考算法说明文档。(Receiver used algorithms and program flow with the sender sends the frame structure of OFDM symbols are. Concrete frame structure and timing estimates, frequency offset estimation, the remaining error tracking algorithm can reference algorithm documentation.)

reduced-order Kilman filter,包括代码和论文(reduced-order Kilman filter, including code and papers)

高斯烟雨模型 gao shi yan yu (dfkdsklfjfjlkfjkldfkjldkjfjkdfkjdjk)

功率谱估计和信号频率估计方法 周期图法 BT法(Power spectrum estimation and the signal frequency estimation methods periodogram )

Local Triplet Pattern

matlab下的三相异步电机模型，可用于仿真(matlab under the three-phase induction motor model can be used for simulation)

This is a book about coding in SIMULINK matlab

控制工具箱与SIMULINK软件应用：系统对象为G(s)=4/s(s+2) PI补偿器K1(s)=(s+1)/s K2(s)=(s+0.5)/s a 若由K1(s)与 G(s)串联组成的单位反馈系统，称为系统A。 b 若由K1(s) 放置在G(s)的反馈通道称为系统B。 c 若由K2(s)与G(s)串联组成的单位称为系统C，绘制上述每一种情况的阶跃响应与斜坡响应，求每一种情况下的系统阶跃响应误差与斜坡响应误差，并与理论分析结果进行比较。 (Control toolbox and SIMULINK software application: system object for G (s) = 4/s (s+ 2) PI compensator K1 (s) = (s+ 1)/s K2 (s) = (s+ 0.5)/s If a by K1 (s) and G (s) series of feedback system of the unit, known as a system a. B if the K1 (s) placed in G (s) feedback channel called system b. If c by K2 (s) and G (s) series of unit is called system c, draw the above each kind of condition of step response and slope response, for each of these cases system step response error and slope response error, and the results were compared with theoretical analysis.)