-
rs
说明: 给出RS编码和译码的原理
以及解决方案,特别是仿真的一种解决方案,值得参考。(RS gives the principle of encoding and decoding as well as solutions, in particular the simulation of a solution, it is also useful.)
- 2007-11-21 23:31:07下载
- 积分:1
-
pmdcmotor
Modelling moto DC controller
- 2010-11-09 10:47:31下载
- 积分:1
-
yidongtongxin
用MATLAb对移动通信中的瑞利信道进行仿真并与理想信道进行对比(matlab abou ruili channel ananlysis)
- 2011-04-23 13:12:25下载
- 积分:1
-
matlab-Two-dimensional-convolution-
用matlab语言编写的二维卷积实现代码,自创代码并在软件中实现了。(Two-dimensional convolution code written in matlab language, and create the code and is realized in software.)
- 2014-08-17 20:13:11下载
- 积分:1
-
xiangxiangxishu
非常实用的关于相像系数的程序,与大家分享,希望能在相像系数仿真上面有所帮助(Very practical program resemblance coefficient, helpful to share with you and hope simulation resemblance coefficient above)
- 2012-10-28 17:16:52下载
- 积分:1
-
goldenstein
黄金分割法的matlab程序,绝对正确,goldenstein(Golden section method of matlab procedures, absolutely correct, goldenstein)
- 2009-03-22 17:03:07下载
- 积分:1
-
0138466EMD
基于EMD的信号分解,在matlab中实现,信号分解,谱变换(EMD-based signal decomposition is implemented in matlab, signal decomposition, spectral transformation)
- 2011-05-27 09:34:38下载
- 积分:1
-
Full_wave_bridge_rectifier
rectifier power electronics system
- 2013-05-05 16:06:21下载
- 积分:1
-
Code_SKFCM
Matlab code for SKFCM for segmentation
- 2015-04-14 15:47:49下载
- 积分:1
-
109201289dg-placement
This paper presents a new method to solve the network reconfiguration problem in the presence of distributed generation (DG) with an objective of minimizing real power loss and improving voltage profile in distribution system. A meta heuristic Harmony Search Algorithm (HSA) is used to simultaneously reconfigure and identify the optimal locations for installation of DG units in a distribution network. Sensitivity analysis is used to identify optimal locations for installation of DG units. Different scenarios of DG placement and reconfiguration of network are considered to study the performance of the proposed method. The constraints of voltage and branch current carrying capacity are included in the uation of the objective function. The method has been tested on 33-bus and 69-bus radial distribution systems at three different load levels to demonstrate the performance and effectiveness of the proposed method. The results obtained are encouraging. (2014-11-17
- 2021-01-15 15:38:46下载
- 积分:1