tone

Ti_C28_GPIO系列模块在在CCS中的编程使用方法(Ti C28 GPIO series module in the CCS in the programming use)

《gps基本原理及其matlab仿真》(西安电子科技大学)里面的程序源代码，都是自己亲自敲上的。这是第5章的。对入门很有用的。(The basic principle of GPS and the matlab simulation (xi an university of electronic science and technology) in the program source code, is knock on yourself. This is the fifth chapter. The introduction is very useful. )

使用模糊控制的风机系统使用了模糊控制，能够轻松的搭建起相关模型(Wind Turbine System Using Fuzzy Control)

matlab中的音频读取程序，包含详尽的注释，以及采样率的设置。(matlab audio sample rate)

说明：  十大算法程序及论文，数学建模必备，基于Matlab(Ten algorithms and papers, mathematical modeling essential, based on Matlab)

三维三自由度机器人仿真程序，可以离线编程(3D three-robot simulation program can OLP)

说明：  用matlab编写的升余弦成形滤波器的产生及画图(Generation and drawing of raised cosine shaping filter)

MATLAB+GUI实现动态画图曲线的源程序代码(MATLAB+GUI dynamic drawing curve of the source code)

针对TMS320DSP5000的AD采样程序(AD sampling procedures for TMS320DSP5000)

两个画蜂窝系统的程序。第一个画出六边形蜂窝图。以（0，0）点为中心(Two paintings cellular system. The first draw hexagonal honeycomb Fig. To (0,0) point as the center)