matlabsetupr2008a

说明：  一个用于机器人控制的PID与CMAC并行控制的源程序(a robot for the PID control with CMAC parallel control of the source)

丰田的专利 电动机控制设备和电动机控制方法(Toyota`s patented motor control equipment, and motor control)

说明：  BUCK 电路、 PID控制器、降压电路、PFC校正(Buck PID controller, PFC control strategy)

fft谐波检测，分析信号的频谱和幅值，相位(fft harmonic detection, analysis of the signal spectrum and amplitude, phase)

盲信号分离技术讲座，入门基础知识介绍，有几个应用例子来说明盲分离(the_seperation_of_blind_signal)

图像处理中用到的一些代码，在MATLAB环境下开发的。(image code.)

说明：  802.11b中CCK11M,CCK5.5M的实现程序，解调用的是FWT算法。(Implementation of 802.11b in the CCK11M program solution is called FWT algorithm.)

结构分析的有限元法与matlab程序设计4-2(Structural analysis of the finite element method and matlab programming 4-2)

Otsu-最大类间方差Matlab代码 最大类间方差法原理：最大类间方差法是由日本学者大津于1979年提出的,是一种自适应的阈值确定的方法,又叫大津法,简称OTSU。它是按图像的灰度特性,将图像分成背景和目标2 部分。背景和目标之间的类间方差 ％ 大,说明构成图像的2 部分的差别越大,当部分目标错分为背景或部分背景错分为目标都会导致2 部 ％ 分差别变小。(Otsu- Otsu Matlab code Otsu Principle : Otsu law by Japanese scholars in the large-1979's, is an adaptive threshold established methodology, also known as big-law, referred to Otsu. It is based on image characteristics of the gray image can be divided into the background and objectives of Part 2. Background and objectives between the between-class variance%, which meant that the two images form part of the greater difference, When some background into the wrong target or part of the background into the wrong target will lead to sub-2% difference becomes smaller.)

OFDM DATA GENERATION