twoview_reconstruction

基于牛顿拉夫逊法的电力系统潮流计算程序，采用MATlab编程(Method based on Newton Raphson power flow calculation program, using MATlab Programming)

估计一个点云数据的表面法线，表面法线是几何体表面的重要属性。(A point estimate the surface normal, surface normal geometrical surface cloud data is an important attribute volume.)

it gives the matlab simulink for the statcom with the battery energy source system

模拟单边带调幅及解调产生300 ~ 3400Hz的调制信号，画出时域波形及频谱；  产生载波信号，频率自定义，画出时域波形及频谱；  产生加性高斯白噪声，画出时域波形及频谱；  单边调幅，画出叠加噪声后的调制信号和已调信号的波形及频谱；  设计滤波器，画出幅频响应图；  解调，画出解调后的信号时域波形及频谱，并对比分析。(Simulation of single sideband amplitude modulation and demodulation )

生成白噪声信号：包括采样频率，最大和最小频率，时间长度，幅值等要求的信号。(Generated white noise signal: including sampling frequency, maximum and minimum frequency, duration, amplitude and other requirements of the signal.)

最小二乘法展開速度快的相位展開,很好的相位展開法(Least mean square method phase unwrapping)

Optimization of PID Parameters Using SIMULIN K and Optimization Toolbox

matlab与C混合编程的实例，求解两个矩阵的和。(An example of matlab-C mixed programming,getting the adding solution of two matrixes.)

说明：  选择映射降低正交频分复用OFDM的峰均比的论文(slm is to reduce the frequency in the papers are better than to as remultiplexing )

This is a good example of how to create amplitude modulation with sampling frequency