Rungekutta4th

最基础的snake检测轮廓边缘方法的代码，用matlab编写，注释清晰完整。(The snake most basic outline of the edge detection method code, matlab written comments clear and complete.)

基于MATLAB的语音滤波器，通过MATLAB使原来的语音信号分别进行带通，高通，低通滤波，得到更好的效果(MATLAB-based voice filter through the MATLAB so that the original speech signal, respectively, for band-pass, high pass, low pass filter, to get better results)

单自由度系统对初始条件和简谐激励相应 由单自由度的运动方程和初始条件得到二阶非齐次常微分方程，它的解有对应的齐次方程的通解和非齐次方程的特接构成。(Single degree of freedom system to initial conditions and the corresponding harmonic excitation Special general solution of the equations of motion and initial conditions by a single degree of freedom to get the second order non-homogeneous ordinary differential equations, its solution has a corresponding homogeneous equation and non-homogeneous equation then constituted.)

perform the Durbin test for balanced incomplete block design

Matlab code to detect (invariant) Blobs in images.

三相交流调压的MATLAB仿真，感觉效果还是挺好的。(MATLAB simulation of three-phase AC voltage, the effect is still feeling quite good.)

这是关于二自由度直升机模型的前向控制和反馈控制的simulink仿真模型(This is the simulink simulation model helicopter model before about two degrees of freedom to control and feedback control)

雷达通信系统的模糊函数的基于线性函数的matlab仿真(Radar system of communication function of fuzzy linear function based on the matlab simulation )

这里面有两个程序，两个都是采用4QAM调制。不过个人觉得第一个更容易懂，因为写的很有条理。我改的那个程序就是根据这个来的。 不过在这里面有个问题就是信道系数只能是由高到低，大家可以试试，改成[0.227 0.46 0.688 0.46 0.227]这个是老师给我的仿真中常用的信道系数，这个成为归一化信道，就是系数平方和为1. 第二个程序没有涉及到信道系数，但是这个程序当中，在128个子载波中，前后有32个空载波，这个在OFDM中也是经常用的，这样可以降低误码率。 (And there are two programs, two are based on 4QAM modulation. But personally feel that the first is easier, because the writing is organized. I changed that procedure is based on the past. However, there is a problem in that there is only channel coefficients from high to low, we can try and change into [0.227 0.46 0.688 0.46 0.227] This is the teacher gave me the simulation channel coefficient commonly used, this became normalized channel, is coefficient of the square and is 1. The second program is not related to channel coefficients, but this program which, in the 128 sub-carriers, the before and after the 32 air carriers, the in OFDM is also often used, which can reduce the error rate.)

這是LEACH 在Matlab環境下可以直接執行的code(This is LEACH in Matlab environment can directly execute code)