RBFnn

利用matlab 仿真 ofdm 通信系统(ofdm by matlab)

实现多种滤波的M函数，比如算数均值滤波、几何均值滤波、谐波均值滤波、逆谐波均值滤波等(M to achieve a variety of filtering functions, such as the arithmetic mean filter, geometric mean filter, harmonic filtering, inverse filtering, harmonic mean)

matlab与apache的安装和配置方法(matlab with the apache installation and configuration method)

说明：  高等应用数学问题的MATLAB求解高等应用数学问题的MATLAB求解(Advanced application of advanced mathematical problem solving application of MATLAB MATLAB to solve mathematical problems)

plotting pattern for antenna

利用VC和Matlab混合编程,Release文件夹下可直接运行，绘出2D和3D图形。并且可以在VC 6.0环境下调试，注意文件夹中的readme文档说明。(Using VC and Matlab to program, Release folder can be run directly, draw 2D and 3D graphics. And it can debugging in VC 6.0 environment, pay attention to the folder readme documentation.)

Plot your multichannel data despite of being real or complex in Matlab. Mreshape reshapes your 3d data by your desired arrangment. Mreshape4 reshape your 4d data

ITU标准下的大气传播衰减计算程序，使用简单方便，只需要输入传播角度，高度，气候环境，即可计算大气传输损耗（不包括自由空间传播损耗）(According to the ITU standard, this program calculates the atmospheric loss. It is simple to use, you only have to input some parameters such as height, elevation angle, etc)

Dissolve Gas Analysis

用局部参数最优化方法设计一个模型参考自适应系统,可调增益的初值Kc(0)=0.2，给定值r(t)为单位阶跃信号，即r(t)=A×1(t)。 要求： 1把连续系统离散化(采样时间可取0.1)。 2编制并运行这个系统的计算机程序(注意调整B值，使系统获得较好的自适应特性)。 3记录ym、yp的曲线 记录kp×kc的曲线 记录广义输出误差e的变化曲线。 4在参数收敛后，让Kp=2变为Kp=1，重新观察Kp×Kc及e的变化曲线。 5找出在确定的B值下，使系统不稳定的A值(阶跃信号的幅值)，并与用劳斯稳定判据计算的结果比较。 (With local parameter optimization method to design a model reference adaptive system, adjustable gain initial Kc (0) = 0.2, for a given value of r (t) for the unit step signal that r (t) = A × 1 ( t). Requirements: a continuous system discretization (sampling time of 0.1 preferred). 2 compiled and run the system computer program (Note B to adjust the value of the system to obtain better adaptive characteristics). 3 records ym, yp curve record kp × kc curve records generalized output error e curves. 4 parameter convergence, let Kp = 2 into the Kp = 1, re-observed Kp × Kc and e curves. B-5 to find value in determining the next, making the system unstable A value (step signal of amplitude), and using Routh stability criterion and the comparison of the results calculated.)