HspiceToolbox

根据GSM协议，实现8PSK调制。其中OPSK是主函数(According to the GSM protocol, to achieve 8PSK modulation. Which is the main function OPSK)

基于matlab-simulink的软件无线电系统的仿真实现(Matlab-simulink simulation system based on software radio realization)

introduction to simulink

复杂背景下的中心定位圆心，霍夫变化的具体应用(Center positioning center of a circle, changing the specific application of Hough)

Digital water marking used in pictures to hide some data

相移光纤光栅长度变化仿真,matlab,(matlab simulink FBG.)

说明：  SV模型程序 对估计出的参数建模拟合并进行比较(SV model program)

交流伺服系统中的死区效应分析与补偿分析了逆变器的死区效应产生的原因及其对交流伺服系统控制性能产生的影响,指出死区补偿的关键 在于电流相位的获取,为了克服实际系统中电流零点的模糊性,提出了一种基于两相静止坐标系下的前馈死 区补偿方法. 该方法通过对三相输出电流一个周期内补偿电压进行傅里叶变换,发现仅需补偿1 ,5 ,7 次谐波 分量即可消除死区效应. 仿真和试验结果验证了这种方法的正确性和可行性.(AC servo system analysis and compensation of dead time effect of the inverter dead time effect causes the impact of the control performance of the AC servo system, and pointed out that the dead time compensation, the key lies in the current phase of the acquisition, in order to overcome the practical zero of the current ambiguity of the system is proposed based on the two-phase stationary coordinate system under the feedforward dead-time compensation method. by the offset voltage of the three-phase output current cycle Fourier transform is found only compensation 1, 5, 7 harmonic components to eliminate the dead time effect. simulation and experimental results verify the correctness and feasibility of this approach.)

利用matlab计算模拟维维安妮体的教程 清晰易懂~(Computer simulation using matlab tutorial Vivian Anne body lucid ~)

增量式PID控制算法Matlab仿真程序 设一被控对象G（s）=50/(0.125s^2+7s),用增量式PID控制算法编写仿真程序（输入分别为单位阶跃、正弦信号，采样时间为1ms，控制器输出限幅：[-5,5],仿真曲线包括系统输出及误差曲线，并加上注释、图例）。(Incremental PID control algorithm Matlab simulation program to set up a controlled object G (s) = 50/(0.125s ^ 2+7s), with incremental PID control algorithm simulation program written (unit step input, respectively, sinusoidal signal sampling time is 1ms, the controller output limiter: [-5,5], including simulation system output and error curve curves, plus notes, legend).)