AnnInMat

实验内容 信号与系统试验报告 自己的作业 1.设有两个信号： 要求x(t)和h(t)采样形成离散序列， 参数选择如下： 采样率Δ=4ms， 频率f=30Hz， a=2f2ln(M), M=2.5 在MATLAB下实现连续信号离散化， 并绘制出离散形式的信号波形。 (Experimental signal and system test the contents of the report of one)

pwm整流器的MATLAB仿真程序，都正确。(MATLAB PWM conventer)

产生一个连续信号，包含低频，中频，高频分量，对其进行采样，进行频谱分析，分别设计低通，带通，高通滤波器对信号进行滤波处理，观察滤波前后信号的频谱。(Generates a continuous signal, including low-frequency, medium frequency, high frequency components, its sampling, spectral analysis, were designed low-pass, band pass, high pass filter for filtering the signal, observed before and after filtering the signal spectrum.)

its a buck converter

基于非下采样轮廓波的边缘提取文献。很好的参考价值(Based contourlet edge extraction literature nonsubsampled. Good reference value)

说明：  DSTBC源码，均可以运行成功，对于在研究DSTBC的朋友会很有帮助，我也希望我能得到其他朋友的帮助，站长手下留情，(DSTBC source can run successfully for the study would be helpful DSTBC friends, I also hope that my other friends can get help, head lenient,)

code matlab progeram graphical model

采用四步相移法的图像生成程序，该图像主要用于三维结构光的重构。(use the four step shift method to produce the image,this image is mainly used for the 3d reconstruction)

基于四元数法的捷联惯导系统仿真，陀螺仪和加速度计数据为自己仿的一分钟数据(Simulation SINS)

一种matlab环境下开关磁阻电机的仿真研究(Under a matlab simulation of switched reluctance motor)