ChiLunJiSuan

RF amplifier matlab-simulink files. Requires RF toolbox to run.

hammer collision with a mass-spring system

matlab小程序实例，对掌握matlab很有用处。(matlab applet instance, the master matlab useful.)

直序扩频系统，首先基带信号通过脉冲成型，m序列扩频然后进行BPSK调制发送，接收端接收到信号加干扰和噪声，进行解调和解扩恢复原始信号。( The straight foreword wide frequency system, the first baseband signal through the pulse formation, the m sequence wide frequency then carries on BPSK the modulation transmission, the receive termination receives the signal to add the disturbance and the noise, carries on the demodulation and the despread restores the primary signal. )

matlab编写的一段提取DCT域共生矩阵的源码(matlab extract prepared DCT section of the source domain co-occurrence matrix)

说明：  matlab提供了rgb2gray的函数，但是如果gray想要换成rgb，就要自己写了。(matlab function rgb2gray provided, but if you want gray into rgb, should write their own.)

Dijkstra最短路算法Matlab程序,用于求从起始点s到其它各点的最短路 D为赋权邻接矩阵需要输入 d为s到其它各点最短路径的长度 pre记载了最短路径生成树(Dijkstra shortest path algorithm Matlab procedures for the request from the starting point s to the other points for the empowerment of the most short-circuit the adjacency matrix D need to enter d for the s points in the shortest path to other pre recorded the length of the shortest path spanning tree)

This code may be useful for sensing spectrum in cognitive radio

this code is very good for TSOM

风向驾驶模型,让驾驶员在驾驶过程中遇到的风速进行仿真。(Wind driving model, so that the driver in driving wind encountered during simulation.)