matlabjuleifenxi

a damping gui source code

说明：  keystone,距离补偿算法，检测运动目标(keystone,distance compensation algorithm to detect moving targets)

有关速率的分岔图程序，图像比较清晰，可下载参考。(For the rate of the bifurcation diagram of the program, the image is relatively clear, can be downloaded reference.)

说明：  通过并行压缩进行二维信号压缩，提出了一种利用并行压缩传感技术对二维信号进行压缩的新方案。根据这个原理，译码器的重新构造可以并行进行。通过对二维信号进行某些排列，可以确保所有列具有大致相同的密度级别，并且可以使用相同的测量矩阵进行采样。这样可以避免二维信号的矢量化，从而大大减小测量矩阵的尺寸。我们证明，如果排列良好，重建均方误差的上限会更紧。为了说明这一方案，我们将其应用于视频压缩并使用不同帧的排列有两种：参考帧的基于Z字形扫描的排列和非参考帧的基于块测试的排列。仿真结果表明，在相同的压缩比下，峰值信噪比比比在无置换情况下可提高3-7db左右。(we propose a new scheme to compress 2D signals using parallel compressed sensing. According to this seheme, the reeonstruction at the decoder can be performed in parallel. By performing certain permutation on a 2D signal, all columns are insured to have approximately the same density level and can be sampled using the same measurement matrix. In this way, vectorization of a 2D signal can be avoided, and thus the size of the measurement matrix can be dramatically reduced. We prove that with a good permutation, we can have a tighter upper bound on reconstruction mean square error. To illustrate this scheme, we apply it to video compression and use two kinds of permutations for different frames: the zigzag-scanbased permutation for reference frames and the block-test-based permutation for non-reference frames. Simulation results show that under the same compression ratio, the peak signal-to-noise ratio can be improved by approximately 3-7 dB compared to the case without permutation.)

制作出来的显示界面，有坐标，相关显示波形(Produced the display interface, with coordinates, related to the waveform display)

无线传感器网的leach协议的实现。基于matlab。。(Wireless sensor networks leach protocol implementation. Based on matlab. .)

在matlab环境下读取两个txt文档中的内容，并实现两个内容的相似性比较(compare with two groups of int number)

matlab gui设计基础教程资料，详细，适合matlab初学者(Matlab based GUI design tutorials, detailed, suitable for beginners matlab)

程序是实现加权线性回归的，自己构造数据吧(this is the linear regression)

Write automatically written to a file using C + + code in order to make ns2 manual routing is used, used to set the node, which is our experimental multichannel implementation, hoping to share.