McCabeThiele

波束形成优化算法,可以很好地实现波束形成，抑制干扰(Beamforming optimization algorithm, can realize beamforming, interference suppression)

费诺编码源程序 如：p=[0.4 0.3 0.2 0.1] fano(p)(fano source code)

说明：  噪声主动控制之基于随机梯度的格型滤波算法；基于随机梯度的格型滤波算法(Active noise control based on stochastic gradient lattice filter algorithm based on stochastic gradient lattice filter algorithm)

结合30个案例详细介绍了matlab神经网络的原理及应用(Principle and application details matlab neural network combined with 30 cases)

编程仿真连续小推力实现GTO到GEO的三阶段转移过程，其中推力器的推力大小为0.8N，轨道机动的起始点为GTO的远地点。GTO轨道的升交点赤经为0度，近地点角距为90度。 GTO轨道： ph:185km，ah：35786km，i：28.5°，GEO轨道：h：35786km，i：0°。 卫星质量为6600kg，从GTO到GEO，采用5000s的推力器。取地球半径为6378km，g取值为9.8m/s^2(The three stage transfer process from GTO to GEO is realized by simulation and continuous small thrust. The thrust of the thruster is 0.8N, and the starting point of orbital maneuver is the apogee of GTO. GTO orbit RAAN is 0 degrees, 90 degrees for the argument of perigee. GTO orbit: ph:185km, ah:35786km, i:28.5, GEO orbit: h:35786km, i:0. The mass of the satellite is 6600kg, from GTO to GEO, using the 5000S thruster. The radius of the earth is 6378km, and the value of G is 9.8m/s^2)

本文首先介绍了边缘的定义，说明了传统的几种边缘检测算子并比较了它们算法的不同与优缺点。随后引入了小波的思想、小波的基本概念， (This paper introduces the edge of the definition, Note some of the traditional edge detection operators and compare them with the different algorithms advantages and disadvantages. The subsequent introduction of wavelet thinking, wavelet the basic concepts,)

图像取证，可用于检测图像CFA插值，并给出正确结果(image forensic)

this program calculate the electric and magnetic fildes in rectangular waveguide it is also calculate resonance modes by fft.

matlab编写的蒙特卡洛模拟计算面积的程序，是学习蒙特卡洛法很好的学习程序！(Monte Carlo matlab prepared simulated area calculation procedures, is to learn the Monte Carlo method is very good learning process!)

matlab Simulink 环境下编写的四分之一车模型，利用经典的四分之一车数学模型进行设计(matlab Simulink environment written in a quarter car model, using the classical fourth mathematical model car design)