genetic_algorithm

本书为石端伟编写的《机械动力学》，介绍了机械动力学相关内容，单自由度、多自由度的响应分析，并附有matlab源代码。(Duan-Wei Shi written book for the " mechanical dynamics," describes the mechanical dynamics relevant content, single degree of freedom, more freedom of response analysis, together with the matlab source code.)

三次样条的插值计算，实验结果很好，经度可达到负二次方。(Cubic spline interpolation, the experimental results very well, longitude to the negative quadratic.)

说明：  层空时码有三种普遍的检测算法：最大似然（Maximum Likelihood ,ML）检测算法、迫零（zero forcing ,ZF）检测算法、最小均方误差（Minimum Mean Squared Error,MMSE）检测算法。(There are three layers in general space-time code detection algorithms: maximum likelihood (Maximum Likelihood, ML) detection algorithm, forcing zero (zero forcing, ZF) detection algorithm, minimum mean square error (Minimum Mean Squared Error, MMSE) detection algorithm.)

three_motor by simulink.

this is bldc simulink file in matlab and sensorlles method for starting.

VC++与Matlab混合编程时，所需的lib库文件压缩包(VC++ and Matlab mix program，need liblibrary rar)

高速公路上关于车流量与速度关系，以及发生事故的可能性。(About the relationship between traffic volume and speed on the highway, and the possibility of accidents.)

matlab code to plot sphere (3d)

说明：  利用Dijkstra算法来求网络图的最短路径，找到从起点P1到终点Pn的最短路径，由于上述算法使用了连接线中点的条件，不是整个规划空间的最优路径，然后利用遗传算法对找到的最短路径各个路径点Pi (i=1,2,…n)调整，让各路径点在相应障碍物端点连线上滑动(Use Dijkstra algorithm to find the shortest path network diagram to find the starting point P1 to the end of Pn from the shortest path algorithm is used as the midpoint of the condition of cable, not the entire optimal path planning of space, and then use genetic algorithm to find shortest path of each path points Pi (i = 1,2, ... n) adjusted to the path of obstacles in the corresponding endpoint connection point slide)

MATLAB的光伏电池模型——采用MATLAB/simulink搭建的光伏电池模型(MATLAB PV cell model)