555_circuits_of_the_oscillator_circuit_Collection

本程序会将WIFI模块发送的数据转发到USART1串口，同时将USART1串口接收到的数据转发给WIFI模块。这样客户就可以通过HL-340的USB转RS232串口线来测试WIFI模块的AT指令了。(The data in this program will be forwarded to the WIFI module sending USART1 serial port, while forwards USART1 receive serial data to WIFI module. So customers can be transferred via RS232 serial cable HL-340' s USB WIFI AT command to test the module.)

说明：  STM32f103ZET6控制超声波测距模块，通过串口显示(STM32f103ZET6 controls the ultrasonic ranging module, which is displayed through serial port.)

lingo学习教程。主要用于优化设计，确定最优方案，分析各分量的约束条件。(Lingo learning tutorial. Mainly for the optimization design, determine the optimal scheme, analysis of the components in the constraint condition. )

瑞萨单片机rl78 iic程序 官方源码 亲测 能用(Renesas MCU rl78 iic official source program   Pro-test can)

这是一个用汇编语言写的关于直流电机调速的程序，里面包括系统框图程序清单和实验总结。(This is a compilation of the language used to write on the DC motor speed control procedures, which include system block diagram of the experimental list and summary procedures.)

cy7c68001驱动程序，主要用于这个usb芯片的驱动(CY7C68001 driver chips used mainly for the usb driver)

matlap 仿真源代码，利用贪心算法实现认知无线电的频谱分配。(matlap simulation source code, the use of greedy algorithm of cognitive radio spectrum allocation.)

《现代电机控制技术》王成元主编的一本很好的关于电机控制的书，详细的讲解了异步电机，同步电机矢量控制直接转矩控制等。(a good book on motor control edited by wangchengyuan)

说明：  利用定时/计数器T0从P1.0输出周期为1s的方波，让发光二极管以1HZ闪烁，设晶振频率为12MHz(The use of timer/counter T0 from P1.0 output cycle square wave 1s, so that the light-emitting diodes 1HZ blinking, set the crystal frequency is 12MHz)

说明：  pscad spwm模型,已仿真，适合新手(pscad spwmModel, simulated, suitable for novice)