Matlab

本程序描述了ofdm的程序，并对程序进行了仿真，并对仿真结果进行了分析(This procedure describes the procedures for ofdm, and process simulation, and simulation results are analyzed)

本程序主要是应用到无线传感器网络目标定位与追踪中，通过利用MUSIC算法来测量接受信号的波达方向角DOA，然后进一步定位与追踪。(This procedure is mainly applied to wireless sensor networks, targeting and tracking, the MUSIC algorithm is used to measure the signal direction of arrival angle DOA, then locate and track.)

说明：  模拟有限元仿真中的力分布，变形量大小分布(force distribution simulation in FEM)

this for 16QAM with AWGN and BERR

说明：  详细介绍了单级倒立摆模型的建立，稳定控制和起摆控制的仿真及实时控制的实现，二级摆和三级摆的控制(Details of the single-stage model of inverted pendulum, stability control and swing control of the simulation and realization of real-time control, secondary and tertiary pendulum swing)

这段代码是基于pca方法的数字图像处理技术，具有实际用应价值(This code is based on the method pca digital image processing technology, with the actual values used should be)

1.分别在两个图中画出δ(n)和δ(n-2)，其中-10≤n≤10，画出U（n）其中-10≤n≤10。 2.分别在两个图中画出x1(n)=cos(2π×20×0.01×n)，0≤n≤10和x2(n)=(0.8)n，1≤n≤6。 3.由上一题，计算y(n)=x1(n)+x2(n)，并画图。(1. Draw the figure at two δ (n) and δ (n-2), where-10 ≤ n ≤ 10, draw the U (n) where-10 ≤ n ≤ 10. 2. Respectively in the two Draw the figure x1 (n) = cos (2π × 20 × 0.01 × n), 0 ≤ n ≤ 10 and x2 (n) = (0.8) n, 1 ≤ n ≤ 6. 3. from the previous question, calculate y (n) = x1 (n)+ x2 (n), and drawing.)

在vc.net 2003中调用Matlab Builder生成的COM组件，与2005中有所不同。(in vc.net 2003 Calling Matlab Builder generated COM, 2005 was somewhat different.)

this simulation is cascade with matlab

this code contain hmm speech recognition