PMHT-2

C++/C编程指南丛书---高质量编程 看过后大受启发 (C++/C Programming Guide--- Series of high-quality programming large inspired after reading)

科研助力的工具，利用a.ishadowx.net/使用(Tools for scientific research)

24C02驱动程序。包含了C语言和头文件程序。(driving code for 24C02)

龙贝格积分 高斯列主消元法 牛顿迭代 三次样条插值 龙格卡塔(Romberg integration Gauss principal elimination method Newton iteration three spline interpolation Runge Cartagena)

115.2k串行口通信程序，校验方式为简单双向校验,而且是必要的，因为任何采用中断、crc等的方法均很难保证速度和避免错误. 总体速度5KB/秒 -115.2k serial port communication procedures and testing methods for the simple two-way check, but is necessary, Any interrupt, crc the methods are difficult to ensure that the speed and avoid mistakes. the overall rate of 5 KB/sec

俄罗斯方块 一个用vb2005编写的。请大家多多指教。-Tetris one written using vb2005. Please exhibitions.

该代码为XML编程与应用教程第二章课后习题实验答案。(The code for XML programming and Application Tutorial second chapter after-school exercise experiment answer.)

说明：  1. 定义了刀具和工件结点的接触，并定义为默认“硬接触” 2. 工件上表面定义了自接触，防止切屑穿透工件上表面 3. 有些情况下可能产生工件右边界的部分结点卷曲后进入上表面，可以额外定义工件上表面与右边界部分结点（在右边界上，但是被切下来的部分结点）的接触算法这样就不会穿透了。(1. Defined the contact between tool and workpiece node, and defined as the default "hard contact". 2. Self-contact is defined on the upper surface of the workpiece to prevent the chip from penetrating the upper surface of the workpiece 3. In some cases, part nodes of the right boundary of the workpiece may curl into the upper surface, and the contact algorithm between the upper surface of the workpiece and the right boundary part node (the part node on the right boundary, but the part node cut off) can be defined in addition, so as not to penetrate.)

对无人机进行了建模，使用PID进行了控制，用于学习(Modeling unmanned aerial vehicle (UAV))

针对室内麦克风阵列仿真信号的产生，有混响，可以添加任意角度的噪声。(For indoor microphone array simulation signal generation, reverberation, can add any angle noise.)