kongzhimatlab

fastSLAM算法的matlab实现， 有GUI仿真界面. (fastSLAM Algorithm Implementation of Matlab, a GUI interface simulation.)

信道估计程序\MIMO-OFDM 系统的信道估计程序，包括导频设计，信道建模,常见的信道估计方法(Channel estimation program MIMO-OFDM system channel estimation procedures, including the pilot design, channel modeling, common channel estimation method)

有限元程序集，非常全面，方便阅读，希望你们能喜欢 (Finite element assembly, is very comprehensive, easy to read, I hope you will enjoy)

说明：  计算分子流态下气体分子通过直圆管道时的角度分布的数值解(Calculation of gas molecules under molecular flow through straight circular pipes of the angular distribution of the numerical solution)

matlab常见错误的提示和原因以及解决方法(matlab tips for the causes of common errors and solutions)

说明：   lms算法源程序 ( lms code )

模糊PID控制算法,对模糊控制与pid的结合的学习有帮助(mo hu pid)

LMS滤波算法，分别对锯齿波、方波、正弦波进行了滤波，并将滤波前后的信号进行了对比，很好的恢复出了真实信号。(LMS filter algorithm. The sawtooth wave, square wave, sine wave are filtered, and the signals are contrasted before and after filtering. The real signals are all well recoveried by this algorithm.)

说明：  任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。 要求： 1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。 2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。 3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)

Tutorial for beginner in matlab