matlab2

将断层剖面划分为一组网格，并以固定的事件数或固定的扫描半径，计算每个网格点处的b值。然后用色彩表示断层面上b值的分布情况，从而反应断层的应力积累情况，便于地震学家分析该断层是否存在发震的可能(This subroutine creates a grid with spacing dx,dy (in degreees). The size will be selected interactively or grids the entire cross section. The b-value in each volume is computed around a grid point containing ni earthquakes or in between a certain radius. The standard deviation is calcualted either with the max. likelihood or by bootstrapping, when that box is checked. If not, both options can be assigned by the additional run assignment. Standard deviation of b-value in non-bootstrapping case is calculated from Aki-formula!)

利用小波分析来对其中找出其中信号的奇异点，并对进行分析。(Using wavelet analysis to figure out which of them singular point signal, and analysis.)

指纹识别系统设计时gabor滤波的一段简单小程序(Fingerprint Identification System gabor filter design for a simple applet)

it s about smart antenna. it can help you whatever it is

信道仿真的源文件，用MATLAB编写而成(channel simulation of the source document, prepared using MATLAB)

matlab 与 word 交互功能演示(the matlab and word interactive features demo)

Huffman coding uses a specific method for choosing the representation for each symbol, resulting in a prefix code (sometimes called prefix-free codes , that is, the bit string representing some particular symbol is never a prefix of the bit string representing any other symbol). Huffman coding is such a widespread method for creating prefix codes that the term Huffman code is widely used as a synonym for prefix code even when such a code is not produced by Huffman s algorithm.

介绍了基于MATLAB和excel的数值分析数值分析方法，(Introduced based on MATLAB and excel in the numerical analysis numerical analysis,)

SIMULINK简明教程，希望对初学者有用(simulink tutorial, I hope useful for beginners)

Locating moving target systems