sweb

Jentzsch求共生矩阵,通过MATLAB来求 公升句镇(Jentzsch for symbiotic matrix, through MATLAB liter sentence to seek town )

how to design a gui in matlab software? this is the solution/

模糊PID控制算法在MATLAB里的仿真程序,(fuzzy PID debug in MATLAB)

this is helpful to get better result in stock market pridiction.

说明：  ：仿真．--f~简化对单相电压型PWM逆变器的分析和设计过程。为此，文章基于状态方程建立了单相 电压型PWM逆变器的数学模型和仿真模型。仿真模型分别考虑了主电路和控制器模型，较为精确地反映了 实际情况。实验表明，以此模型为基础的控制方案是可行的。(: Simulation.- F ~ simplify the single-phase voltage PWM Inverter analysis and design process. To this end, the article was based on state equation, single-phase voltage-type PWM inverter model and simulation model. Simulation model were considered the main circuit and the controller model, more accurately reflect the actual situation. Experiments show that this model-based control scheme is feasible.)

实现一个LCC滤波 电感Lr，电感电阻R，与电感串联的电容Cr，输出并联电容Co(achieve a filter inductor Lr, inductance and resistance R, the series inductor and capacitor Cr, Parallel output capacitance Co.)

music静态DOA，经典算法，附有详细注释，适合学习。直接运行，是两个角度的DOA，可以改为三个信号，同时需要把子程序中的输出改成三个即可。(music static DOA, classical algorithm, with detailed notes, suitable for learning. Run directly, the DOA of two angles can be changed to three signals, at the same time need to change the output of the subroutine three can.)

盲源分离的自适应在线学习方法，采用最大熵，四个源信号，四个混合信号和自然梯度方法(Adaptive online learning method for blind source separation using the maximum entropy, four source signals, four mixed-signal, and the natural gradient method)

说明：  电力电子12脉冲（NVDC），大多数matlab版本会缺失的库文件(Power electronics 12 pulse (nvdc))

传统的决策树能较好地解决分类问题，但当类的个数增多时，所产生的单一决策树就会变得复杂，同时概括能力降低。 该文采用基于层次分解的方法通过产生多层决策树来处理多类问题。 与传统的单一决策树比较， 基于层次分解的决策树在处理多类问题时有许多的优势。(induction learning,decision tree,id3 ,hiberarchy decomposition)