基于DSP的驾驶疲劳检测系统 非常好的设计资料

dsp 5509a MMC 卡 ID号读取 12Mhzx16=192M-dsp 5509a MMC card reader ID No. 12Mhzx16 = 192M

一般了 一般了 一般了 一般了 一般了 一般了 一般了 一般了 一般了 一般了 一般了-sosososo soso soso soso soso soso soso soso soso soso soso soso soso soso soso soso

一个TMS320　5402与51芯片，其中以51来自举的程序．软件　是CCS打开．有兴趣看一下．用51驱动TMS320 5402-TMS320 5402 with a 51 chips, which held 51 from the procedure. CCS software is opened. Are interested in reading about. Drivers with 51 TMS320 5402

基于TI公司的dsp芯片TMS320F2812读写外扩空间的源代码，已经在CCS2.2环境下测试通过。-Based on TI

这是一个学习dsp的知识手册，介绍了dsp软硬件设计-this is a handbook of learning dsp,it introduces the dsp hardware and software design.

硬件要求：基于合纵达的SEED-VPM642的示例。软件要求：CCS2.2以上版本。对于想用DSP/BIOS开发的同道中人来说是很好的学习实例。-Hardware Requirements: Based on the combined vertical up the SEED-VPM642 example. Software Requirements: CCS2.2 above. For want to use DSP/BIOS development for the fellow human is a very good learning examples.

2812DSP串口使用方法，在RAM中调试，应经通过测试。-2812DSP serial port to use, in the RAM in the debugger, it shall be tested.

源程序是在VisualDSP环境下开发出来的，目标处理器是4片AD公司的TS1O1 DSP。IDE_FAT32用来在硬盘上创建FAT32文件系统；2）i2c_test编写IIC总线；3）codec_a_in_pal_cf_frame是加载到FLASH的程序，板子在脱离PC自动上电时会把PAL制的图像直接存到CF卡里，CF卡的文件系统是FAT16；4）codec_a_in_pal_buf_boottest是可加载的DSP图像直通程序；5）ADSP-TS101prog_driver是flash的驱动程序。-source of the VisualDSP environment developed, targeted four processor is the company"s AD TS1O1 DSP. IDE_FAT32 used in the drive to create FAT32 file system; 2) to prepare i2c_test IIC bus; 3) codec_a_in_pal_cf_frame FLASH is loading procedures, the board automatically from the PC on when power will be the PAL system images directly to CF card, the CF card is the FAT16 file system; 4) can be loaded codec_a_in_pal_buf_boottest DSP image through procedures; 5) ADSP-TS101prog_driver flash is the driver.

TMS320LF2407 sci language code

TI TMS320C6X系列DSP上DSP逆变换汇编代码-TI DSP TMS320C6X Series DSP inverse transform compiled code