A/D转换器ADC0832驱动程序，该程序属于A/D的基础程序，可以调用该函数来实现A/D转换...

MSP430下的一个微内核操作系统，很实用。做到底层无关，稍加修改可以移植到其他平台下。-MSP430 under a micro-kernel operating system, is very practical. Do not bottom, a little change can be transferred to other platforms.

keil c51平台,此代码可用于学习TFT LCD TV 搜台等,(本人自己修改) -keil c51 platform, this code can be used to study seized Taiwan TFT LCD TV and so on, (my own modifications)

这是一个在在Dynamic C环境下实现的设备web服务器的建立，通过它可以通过web方式管理设备。注意main函数中导入网页的目录要跟你实际的目录一样。-This is a Dynamic C in the environment under the equipment of the establishment of the web server, Through its way through the web management equipment. Attention to the main function of the directory into the website actually tell you the same directory.

利用UP-NETARM3000 嵌入式实验平台上的A/D转换器、直流电机、LED和LCD模拟车辆的里程表盘系统。A/D转换器模拟汽车的油门和变速系统；直流电机模拟汽车发动机；LED显示车辆总里程数；LCD模拟当前车辆的速度-UP-NETARM3000 using experimental platform embedded A/D converters, DC motor, LED and LCD odometer vehicles simulated disk system. A/D converter analog throttle and variable-speed motor vehicle system DC motor simulation of automotive engines LED display gross vehicle mileage LCD analog current vehicle speed

单片机课程设计，使用温度传感器，通过液晶显示屏读取温度值-SCM curriculum design, the use of temperature sensors, through the LCD display reads the temperature value

32位arm9微处理器S3C2410的iis音频总线测试源代码-32-bit ARM9 microprocessor S3C2410 the iis audio bus test source code

用过采样和求均值技术提高模数转换器的分辨率.pdf-----针对目前单片机内嵌的模／数转换器的分辨率太低，而外接高分辨率成本又太高的情况，提出了用“过采样和求均值”的技术来使在有用的测量频带内的信噪比得到改善，从而提高测量的分辨. 率。并利用 60 - 7 0 /对其结论进行仿真，且在单片机上予以实现，结果表明测量分辨率明显提高。-Sampling and averaging techniques used to improve the resolution of ADC. Pdf----- targeted at the embedded microcontroller A/D converter resolution is too low, while the external high-resolution costs are too high situation, put forward with " Oversampling and Averaging" technology to make useful measurements in the frequency band signal to noise ratio to be improved, thereby enhancing the measurement resolution. rate. And a 60- 7 0/simulation of its conclusions, and in the SCM to be achieved, results show that the measurement resolution has improved significantly.

本程序为数码管显示处理模块 占用I/O RC3,RC4,RC5 使用RAM 节 程序包括: InitSPI 初始化SPI子程序 LEDlight 送七段码显示子程序 入口参数 LED_DATA 出口参数 无-This procedure for the digital display processing module occupied I/O RC3, RC4, RC5 use RAM section include: InitSPI initialize SPI sent to Seven-Segment Subroutine LEDlight code display subroutine parameter exports LED_DATA entrance parameters without

本文详细系统地介绍了uC/OS-II 在51 单片机上的移植、重入实现方法、硬件仿真、固化、人机界面等关键内容。-paper detailed and systematic introduction of the Phone/OS-II in 51 MCU transplant and re-entry method, hardware simulation, curing, the man-machine interface and other key elements.

频率计的设计,单片机初学者必须程序,适用于proteus-Frequency of the design, single-chip microcomputer program for beginners to be applicable to proteus