Avr microcontroller based on a displayed string 74hc164 into the simulation (pro...

这是参加电子设计大赛时的作品：红外遥控小车：用红外线通过一块AT89S52单片机发射信号即编码，并用红外接收头接收信号；接着再用另一块AT89S52单片机对红外发射出的信号编码进行解码，最后再用一块AT89S52单片机用解码所得码值编写程序后驱动步进电机。步进机功能启动后不仅能使受控小车向前后左右四个方向前进和转弯，而且还能控制小车再地上转动并留下方形或圆形等形状。-This is the time to participate in Electronic Design Contest works: infrared remote control car: Using infrared transmission signal through an AT89S52 microcontroller that is encoded and used infrared receiver to receive the first signal and then using the other an infrared emitting MCU AT89S52 code and decode the signal and finally an AT89S52 microcontroller then proceeds with the decoding key value of the preparation of procedures to drive a stepper motor. Stepper machine function activated not only make the car forward in a controlled direction and after about four turns, but also to control the car and then turned and left the ground such as square or round shapes.

51单片机定时器计算工具，对于经常使用定时器的编程者很有用的-51 Single-chip timer calculation tool, often used for programmers timer useful

c8051f020 i2c 源码。对其操作有详细描述。-dvsah dfvdnjkg b fdv

Linux下51汇编器的设计及实现-Linux compilation of Design and Implementation

51 单片机的经常用到的子函数，非常具有参考价值。-51 SCM Functions frequently used, very useful.

电池供电单片机系统延长使用时间的几点有效措施-battery-powered SCM system to extend the use of time a few effective measures

将单片机的IOA0~IOA7分别接按键S1~S8连接到高电平上。此时，如果某个按键被按下，对应的I/O端口就会输入高电平进单片机，即按键S3按下，IOA2会输入高电平进单片机-Will Singlechip IOA0 ~ IOA7 access keys, respectively, S1 ~ S8 is connected to high on. At this point, if a button is pressed, the corresponding I/O port will enter into the high single-chip, that is, S3 button press, IOA2 will enter into single-chip high

avr 资料 刚刚学习的会有一些帮助 与大家分享-avr information will be just learning to share with you some help

powerpc原理图 vhdl开发 RDMPC8260RTRLAYSCH.zip-powerpc schematic VHDL development RDMPC8260RTRLAYSCH.zip

C8051F04x单片机PCA（可编程计数器阵列）检测UART0波特率。-C8051F04x Singlechip PCA (Programmable Counter Array) UART0 baud rate detection.