嵌入式系统编程源代码解析光盘.iso,将文件后缀改为iso，用解压软件如winrar解压后即可...

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

单片机通信源程序,为串口的发送和接收程序.-Single-chip communication source for the serial port of the sending and receiving procedures.

可编程微波炉系统, at89c52单片机 汇编-programmable microwave systems, at89c52 MCU Series

电脑绣花机锯齿电机控制程序，提升电机控制程序！-Computer embroidery machine zigzag motor control procedures, procedures to enhance motor control!

温度传感器DS18B20的读写程序，是单片机一测的程序，基于h3664F单片机

LCD1602液晶显示器的驱动程序,是用AVR的M16L来驱动的.-LCD1602 LCD driver, is to use the AVR to drive the M16L.

之前看过论坛上有一个C8051和S3530A的通信程序，但我认为很复杂而不具有通用性，我自己写的一个3530通过I2C总线与单片机的通信程序,虽然很短,但是很实用.-Read before the forum have a C8051 and S3530A communications procedures, but I think very complex and not universal, and I wrote it myself a 3530 through the I2C bus communication with the SCM process, although very short, but very practical .

家电智能控制统一主机 -Intelligent Control of a unified appliance console

tlc2543的驱动c程序，次程序已经用过，还不错，他的接线图比较简单，就不传了。-TLC2543 driver c procedures, meeting procedures have been used, but also good, and his relatively simple wiring diagram, not passed.

基于AT89S52单片机的电子万年历设计制作的汇编程序-AT89S52-based single-chip design of the electronic calendar of the assembler