基于MSP430的CO报警器的设计.有硬件电路,放大电路的分析,对做工业仪表人有帮助...

LT_1B msp430开发板例子程序－TA_10

采用实时芯片DS1302来计时,并用LCM液晶显示!有较高的精确度!-Real-time chip DS1302 to time, and LCD LCM! Have higher accuracy!

用汇编语言编写的超声波测距控制源程序采用AT89S51,12ＭＨz晶振 -Prepared by using assembly language source code control using ultrasonic ranging AT89S51, 12MHz crystal

基于单片机的USB通信程序，包括完整的通信协议-SCM USB-based communication program, including a complete communication protocol

带农历显示的万年历,功能齐全，附电路图，可以做产品。-With the Lunar calendar display, complete functions, with schematics, can make products.

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

显示界面的显示程序显示 界面的显示程序-Show interface show interface display program to display the show interface display program

单片机控制串口鼠标芯片范例，实现方向判断和数值计算功能-SCM serial mouse chip sample, judge and realize the direction of numerical functions

用ATmega8单片机产生占空比可变PWM方波-ATmega8 generated by single-chip PWM variable duty cycle square wave

STC isp应用程序，ISP功能，好东西 S TC isp应用程序，ISP功能，好东西 -STC isp applications, ISP, good things S TC isp applications, ISP, the good stu