自己编的一个简单的浏览器程序,功能简洁 减少损耗

基本的粒子群优化算法程序，用Matlab实现，非常简单。(pso code)

仿真程序：首先需要用一个随机发生器产生（0.1）内的均匀随机数，然后再将该序列映射到对应的幅度电平｛Am｝。然后将这个范围再分成4个相等的区间，这些子区间分别对应于4个信号比特的符号00，01，10，11。检测器观察到r=Am+n，并且计算r和4种可能传输的信号幅度之间的距离，它的输出Bm就是相应于最小距离的信号电平。Bm与真正的的传输信号幅度比较，差错计数器用来对检测器产生的差错计数。(Simulation program: first need to use a random generator (0.1) the uniform random number, then the sequence is mapped to the corresponding amplitude level {Am}. Then this range has been divided into four equal intervals, these sub-intervals corresponding to four signal bits of the symbol 00,01,10,11. Detector observed r = Am+ n, and calculate r and 4 possible transmission distance between the signal amplitude, its output corresponding to the minimum distance Bm is the signal level. Bm and the real rate of transmission of the signal comparison, error detection counter is used to generate the error count.)

finds the longest common subsequence.

多核学习+SMO算法的代码实现，包括java版本、python版本和C++版本(Multiple Kernel Learning and the SMO Algorithm)

蓝牙模块nRF52810_UART

此程序为排序问题的源程序,其具有较高的精度,供大家参考,(This program is the source program of sorting problem, it has high precision, for your reference,)

说明：  进行温湿度传感在串口显示波特率为115200，也可以在lcd上显示需要添加相应的驱动文件(The baud rate of temperature and humidity sensor is 115200 on serial port, and the corresponding driver files can be added on LCD.)

说明：  基于51单片机的按键例程，常见问题： 1. 按键无反应 请您确认程序是否下载成功，连线正确无误，确认无误后还是无效果的话，将排线重新插拔下，单片机拿下来重新安装，重启开发板试试！(Key routines based on 51 single chip microcomputer,common problems: 1. Press the key and no response. Please confirm whether the program was downloaded successfully and the connection is correct. If it is still ineffective after confirmation, plug and unplug the cable again, take down the MCU and reinstall it. Restart the development board to try!)

C++实现的CE内存搜索遍历查询工具，可以查询内存的数值，遍历属性、选择数值类型等等，功能强大，代码整洁，建议初学者多看看~

可虛擬兩個RS-232或者是多個RS-232互傳資訊，此源码維BCB6所編寫。(Can be a virtual two RS-232 or RS-232 over pass each other information, this source code written by Victoria BCB6.)