USB上位机驱动的DEMO程序源代码,基于ARM或其它下位机的上位机驱动...

usb驱动及接口通信的汇编版本-usb drive and communication interfaces version of the Compendium

usb 2.0 cy7c68013 pdf file

usb_D12+8051的固件源码. Keil_C51环境下编译-usb_D12 8051 firmware source. Keil_C51 environment compiler

制作安装程序必备此模块包含的SUB及Function能帮你做出专业的安装程序-production procedures required to install this module includes the SUB and Function professional can help you make the installation procedure

USB设备端固件程序,枚举部分是全部程序的基础和重心,只有主机对设备枚举成功后,主机才能和设备进行正常的通信 USB的枚举过程分为4个状态. 1.接入态 v主机检测到USB设备插上,击活端口,并发送复位命令(保持10ms) 2.默认态 v主机使用默认地址读取设备描述符 (GET_DESCRIPTOR) v主机分配给设备一个总在线的唯一地址 (SET_ADDRESS) 3.地址态 v主机从新的地址获取设备描述符(GET_DESCRIPTOR) v主机获取所有设备的配置描述符(GET_DESCRIPTOR) 4.配置态 v主机设置描述符(设备,配置) (SET_CONFIGURATION) v主机读取配置状态(可选) (GET_CONFIGURATION) v主机读取接口状态(可选) (GET_INTERFACE) -USB device-side firmware, enumerate all part of the foundation and focus of the procedure, only the host of equipment after the successful enumeration, the host and equipment in order to engage in normal communication USB enumeration process is divided into four status. 1. Access state v host detected USB devices plug in, hit live ports, and send the reset command (to maintain 10ms) 2. default state v Use the default address of the host to read device descriptor (GET_DESCRIPTOR) v host assigned to the equipment of a total online only Address (SET_ADDRESS) 3. A

该程序用以通过单片机来控制芯片CH375 实现对海量存储器的读写操作-procedure for the adoption of the single-chip microcomputer to control chip to achieve CH375 Massive Memory read and write operation

10分钟完成一个USB驱动程序-10 minutes to complete a USB Driver

这个一个usb接口芯片ch372的，上位机（PC）机程序，用vc编写。-this one usb interface chip ch372, PC (PC) Program, prepared using vc.

Cy3663的USB主机固件程序-Cy3663 the USB Host Firmware

USBTraceV2.2.7.57 USB调试工具-USBTraceV2.2.7.57 USB debugging tools