dsp fft example for Ti c64

DSP的PWM电机控制程序,正反转,默认设置的工作频率1kHz-DSP s PWM motor control procedures, positive, the default settings of the operating frequency of 1kHz

设计一套由 CPU 开环控制的单相可控整流装置电网同步信号在进入单片机A/D端口之前，经过了两级运放和RC低通滤波，因而造成2ms的延时，相当于相角滞后了π/

在ccs中调试DSP外部存储sdram的反色代码，主要是通过dsp/bios中的HST管道实现的。其中选用的是DM642芯片及MT48LC16M16A2的sdram，且sdram的相关时序参数已配置好。-In ccs debug DSP external memory sdram of the anti-color code, mainly through the dsp / bios in the HST pipeline implementation. One choice is the DM642 chip and MT48LC16M16A2 the sdram, sdram and the related timing parameters have been configured.

介绍了基2时域抽取法FFT的原理和算法,并在MATLAB仿真软件的辅助下、在数字信号处理 DSP上实现。 -Describes the radix-2 time-domain extraction principle and FFT algorithms, and the aid of MATLAB simulation software, in digital signal processing DSP to achieve.

TMS320LF2407 DCMotor

基于TMS320VC5402 DSP平台的定时器中断程序，使用的汇编语言，在CCS里调试通过。-Based on TMS320VC5402 the DSP platform timer interrupt program,with assembly language, debugs in CCS passes

H.264 编解码程序，希望对各位有用，同时加强交流是才主要目标-H.264 codec procedures, in the hope that useful, at the same time to strengthen the exchange is only the main objectives of

实现FPGA与DSP之间通信的接口,利用DSP的标准EMIF接口-the interface for TI DSP and Xilinx s FPGAs

这是测试SEED-VPM642系统中两路串口及开入与开出的程序。-This is a test SEED-VPM642 system and an open two-way serial port into and out procedures.

ti c6713 芯片的实现外扩usb的编程和子程序，usb芯片位cypress的68001，主机和丛机都已经实现-ti c6713 expansion outside realize chip usb programming and subroutines, usb digital cypress of the 68001 chip, host and cluster machines have been achieved