Digital signal processing assembly, it is practical, full of all kinds of signal...

埠使用的差分法离散小波变换 （dwt） 和平均计算。

用dsp解压mp3程序的算法，感觉很好，很有用，可以-with dsp decompression procedures MP3 algorithm, feel good, useful and can s

采用matlab编程的DTMF检测程序仿真，经过测试，绝对可用，可检测多个DTMF信号！-using Matlab programming DTMF detection process simulation, tested and absolutely can be used, can detect DTMF signals over!

单一图像的读取，小图像的放大，开发环境DSP++4.0，有一些底层设置。-Read a single image, small image to enlarge, development environment DSP++4.0, there is some underlying set.

针对ADSP-BF533开发板的例程，关于ISP1582，可以直接引用，软件开发环境为VisualDSP-For ADSP-BF533 development board of the routine, on the ISP1582, can be directly quoted, software development environment for VisualDSP

TMS320F28xx或28xxx模拟接口设计附件与源码,TMS320F28xx或28xxx模拟接口设计-TMS320F28xx or 28xxx simulation interface design and source the annex, TMS320F28xx or 28xxx Simulation Interface Design

DSP培训 作业【源码】 -DSP training operations [Source]

Ti公司的dsp控制电机的c语言范例-the dsp Ti motor control paradigm language c

经典的DSP程序,仅供学习使用。这是从网上找来的，里面的程序都是可以直接用的，请大家只做学习参考！谢谢！-program

源程序是在VisualDSP环境下开发出来的，目标处理器是4片AD公司的TS1O1 DSP。IDE_FAT32用来在硬盘上创建FAT32文件系统；2）i2c_test编写IIC总线；3）codec_a_in_pal_cf_frame是加载到FLASH的程序，板子在脱离PC自动上电时会把PAL制的图像直接存到CF卡里，CF卡的文件系统是FAT16；4）codec_a_in_pal_buf_boottest是可加载的DSP图像直通程序；5）ADSP-TS101prog_driver是flash的驱动程序。-source of the VisualDSP environment developed, targeted four processor is the company"s AD TS1O1 DSP. IDE_FAT32 used in the drive to create FAT32 file system; 2) to prepare i2c_test IIC bus; 3) codec_a_in_pal_cf_frame FLASH is loading procedures, the board automatically from the PC on when power will be the PAL system images directly to CF card, the CF card is the FAT16 file system; 4) can be loaded codec_a_in_pal_buf_boottest DSP image through procedures; 5) ADSP-TS101prog_driver flash is the driver.